Acura TSX / Honda Accord CL. Manual - part 740

Fig. 110: Holding The Gearbox Housing Using A C-Clamp & Wooden Blocks 

67. Coat the inside surface of the cylinder end (A) with power steering fluid, then install the cylinder end by 

screwing it into the cylinder (B). Tighten the cylinder end to the specified torque. 

 

2004 Acura TSX 

2004 STEERING Power Steering System - TSX

  

 

Fig. 111: Installing The Cylinder End By Screwing It Into The Cylinder & Staking 

68. Stake the point of the cylinder shown (opposite from where the stake was removed during disassembly).  

69. Coat the NEW O-ring (A) with multipurpose grease, and carefully fit it on the valve housing. 

 

2004 Acura TSX 

2004 STEERING Power Steering System - TSX

  

 

Fig. 112: Installing The Valve Body Unit By Engaging The Gears 

70. Apply multipurpose grease to the needle bearing (B) in the gearbox housing, then install the valve body 

unit (C) by engaging the gears. Note the valve body unit installation position (direction of the line 
connections).  

71. Tighten the flange bolts (D) to the specified torque.  

72. Install the cylinder lines. Note these items during reassembly: 

z

Thoroughly clean the joints of the cylinder lines. The joints must be free of foreign material.  

z

Install the cylinder lines by tightening the flare nuts by hand first, then tighten the flare nuts to the 
specified torque.  

 

2004 Acura TSX 

2004 STEERING Power Steering System - TSX

  

 

Fig. 113: Installing The Cylinder Lines 

73. Apply multipurpose grease to the sliding surface and circumference of the rack guide (A), and install it 

onto the gearbox housing. 

 

2004 Acura TSX 

2004 STEERING Power Steering System - TSX