Acura TSX / Honda Accord CL. Manual - part 522

 

  Index      Acura     Acura TSX 2004-2008 / Honda Accord CL 2006-2008 - service repair manual

 

Search            copyright infringement  

 

 

 

 

 

 

 

 

 

Content   ..  520  521  522  523   ..

 

 

Acura TSX / Honda Accord CL. Manual - part 522

 

 

Fig. 21: Checking For Continuity Between Throttle Actuator Control Module 16P Connector 
Terminals No. 10 And No. 12
 

Is there continuity? 

YES - Go to step 12. 

NO - Substitute a known-good throttle actuator control module (see THROTTLE ACTUATOR 
CONTROL MODULE REPLACEMENT
 ), then go to step 16 and recheck. If DTC P2135 is not 
indicated, replace the original throttle actuator control module (see THROTTLE ACTUATOR 
CONTROL MODULE REPLACEMENT
 ), then go to step 16. 

13. Disconnect the throttle body 6P connector.  

14. Check for continuity between throttle actuator control module 16P connector terminals No. 10 and No. 

12. 

 

2004 Acura TSX 

2004 ENGINE PERFORMANCE Electronic Throttle Control System - TSX

  

 

Fig. 22: Checking For Continuity Between Throttle Actuator Control Module 16P Connector 
Terminals No. 10 And No. 12
 

Is there continuity? 

YES - Repair short in the wire between the TPSA line and the TPSB line, then go to step 16. 

NO - Go to step 14. 

15. Turn the ignition switch OFF.  

16. Replace the throttle body (see THROTTLE BODY REMOVAL/INSTALLATION ).  

17. Turn the ignition switch ON (II).  

18. Reset the ECM/PCM with the HDS.  

19. Do the ECM/PCM idle learn procedure (see ECM/PCM IDLE LEARN PROCEDURE ).  

20. Check for Temporary DTCs or DTCs in the DTCs MENU with the HDS. 

Are any Temporary DTCs or DTCs indicated? 

YES - If DTC P2135 is indicated, check for poor connections or loose terminals at the throttle body and 

 

2004 Acura TSX 

2004 ENGINE PERFORMANCE Electronic Throttle Control System - TSX

  

 

the throttle actuator control module, then go to step 1. If any other Temporary DTCs or DTCs are 
indicated, go to the indicated DTC troubleshooting. 

NO - Troubleshooting is complete. 

DTC P2122: APP SENSOR A CIRCUIT LOW VOLTAGE 

1. Turn the ignition switch ON (II).  

2. Check APP SENSOR-A in the DATA LIST with the HDS. 

Is there about 0.1 V, or less with the accelerator pedal fully pressed? 

YES - Go to step 3. 

NO - Intermittent failure, system is OK at this time. Check for poor connections or loose terminals at 
APP sensor A and at the ECM/PCM. 

3. Turn the ignition switch OFF.  

4. Disconnect the APP sensor 6P connector.  

5. Turn the ignition switch ON (II).  

6. At the wire harness side, measure voltage between APP sensor 6P connector terminals No. 5 and No. 6. 

 

2004 Acura TSX 

2004 ENGINE PERFORMANCE Electronic Throttle Control System - TSX

  

 

Fig. 23: Measuring Voltage Between APP Sensor 6P Connector Terminals No. 5 And No. 6 

Is there about 5 V ? 

YES - Go to step 7. 

NO - Go to step 15. 

7. Turn the ignition switch OFF.  

8. At the sensor side, measure resistance between APP sensor 6P connector terminals No. 4 and No. 6 with 

the throttle fully closed. 

 

2004 Acura TSX 

2004 ENGINE PERFORMANCE Electronic Throttle Control System - TSX

  

 

 

 

 

 

 

 

 

Content   ..  520  521  522  523   ..