Acura TSX / Honda Accord CL. Manual - part 513

Fig. 18: Measuring Brush Length 
Courtesy of AMERICAN HONDA MOTOR CO., INC. 

OVERRUNNING CLUTCH TEST 

1. While holding the drive gear (A), turn the gear shaft (B) clockwise. See Fig. 19 . Check that the drive 

gear comes out to the other end. If the drive gear does not move smoothly, replace the gear cover 
assembly.  

2. While holding the drive gear, turn the gear shaft counterclockwise. The gear shaft should rotate freely. If 

the gear shaft does not rotate smoothly, replace the gear cover assembly.  

3. If the starter drive gear is worn or damaged, replace the overrunning clutch assembly; the gear is not 

available separately. Check the condition of the torque converter ring gear to see if the teeth are damaged. 

 

2004 Acura TSX 

2004 STARTING & CHARGING SYSTEMS Starter - TSX

  

 

Fig. 19: Inspecting Overrunning Clutch 
Courtesy of AMERICAN HONDA MOTOR CO., INC. 

REMOVAL & INSTALLATION 

STARTER 

Removal 

1. Ensure you have the anti-theft codes for the radio and the navigation system, write down the frequencies 

for the radio's preset buttons.  

2. Disconnect the battery negative cable. Disconnect the positive cable.  

3. Remove the intake manifold cover. See Fig. 20 .  

4. Disconnect the starter cable (A) from the "B" terminal. Disconnect the Black/White wire (B) from the "S" 

terminal.  

5. Remove the harness clamp (C). See Fig. 21 .  

6. Remove the harness holder (D).  

 

2004 Acura TSX 

2004 STARTING & CHARGING SYSTEMS Starter - TSX

  

 

7. Remove the two bolts holding the starter. Remove the starter.  

Fig. 20: Removing Intake Manifold Cover 
Courtesy of AMERICAN HONDA MOTOR CO., INC.

 

2004 Acura TSX 

2004 STARTING & CHARGING SYSTEMS Starter - TSX

  

 

Fig. 21: Removing Harness Clamp And Holder 
Courtesy of AMERICAN HONDA MOTOR CO., INC.

 

2004 Acura TSX 

2004 STARTING & CHARGING SYSTEMS Starter - TSX