|
|
1. If the engine is out of the vehicle, go to step 16 . 2. Raise the hoist to full height. 3. Drain the engine oil (see ENGINE OIL REPLACEMENT ). 4. Remove the front tires/wheels. 5. Remove the splash shield (see step 18 of TRANSMISSION REMOVAL ). 6. Disconnect the stabilizer links (see STABILIZER LINK ). 7. Remove the right side damper fork (see step 3 of LOWER ARM ). 8. Disconnect the right side suspension lower arm ball joint (see step 12 of KNUCKLE/HUB/WHEEL BEARING ). 9. Remove the right side driveshaft (see step 10 of FRONT AXLE SHAFTS ). Coat all precision-finished surfaces with clean engine oil. Tie plastic bag over the driveshaft end. 10. Lower the hoist. 11. Remove the front mount stop, then remove the front mount bolt (see step 46 of Engine Removal ). 12. Remove the rear mount stop, then remove the rear mount bolt (see step 47 of Engine Removal ). 13. Remove the ground cable, then remove the upper bracket (see step 42 of Engine Removal ). 14. Remove a bolt securing the side engine mount bracket, then attach the special tool as shown.
2004 Acura TSX 2004 ENGINES 2.4L DOHC VTEC - TSX
|