Acura TSX / Honda Accord CL. Manual - part 406

Fig. 18: Removing The Bracket Plate 

46. Remove the vacuum hose (A) from the vacuum line. Remove the front mount stop (B) and vacuum hose 

clamp bracket (C), then remove the front mount bolt (D). 

 

2004 Acura TSX 

2004 ENGINES 2.4L DOHC VTEC - TSX

  

 

Fig. 19: Removing The Front Mount Stop 

47. Remove the rear mount stop (A), then remove the rear mount bolt (B). 

 

2004 Acura TSX 

2004 ENGINES 2.4L DOHC VTEC - TSX

  

 

Fig. 20: Removing The Rear Mount Stop 

48. Check that the engine/transmission is completely free of vacuum hoses, fuel and coolant hoses, and 

electrical wiring.  

49. Slowly raise the engine about 150 mm (6 in.). Check once again that all hoses and wire are disconnected 

from the engine/transmission.  

50. Raise the engine and transmission assembly all the way, and remove it from the vehicle.  

ENGINE INSTALLATION 

 

2004 Acura TSX 

2004 ENGINES 2.4L DOHC VTEC - TSX

  

 

1. Install the accessory brackets and tighten their bolts and nuts to the specified torques. 

Fig. 21: Installing The Accessory Brackets 

2. Install the engine and transmission assembly into position in the vehicle, then remove the engine tilt 

hanger set from the engine. 

NOTE:

Reinstall the mounting bolts/support nuts in the sequence given. Failure to 
follow this sequence may cause excessive noise and vibration, and reduce 

 

2004 Acura TSX 

2004 ENGINES 2.4L DOHC VTEC - TSX