Acura TSX / Honda Accord CL. Manual - part 367

Fig. 1: Identifying Component Locations 
Courtesy of AMERICAN HONDA MOTOR CO., INC. 

TROUBLE SHOOTING 

STARTER CIRCUIT TROUBLE SHOOTING 

 

2004 Acura TSX 

2004 STARTING & CHARGING SYSTEMS Starter - TSX

  

 

Recommended Procedure 

Manufacturer recommends to use a starter system tester. Connect and operate the equipment in accordance with 
the manufacturer's instructions. For starter circuit trouble shooting procedure chart, see Fig. 2 .

NOTE:

z

Air temperature must be between 59° and 100°F (15° and 38°C) during this 
procedure.  

z

After this test, or any subsequent repair, reset the Engine Control Module 
(ECM)/Powertrain Control Module (PCM) to clear any codes.  

z

The battery must be in good condition and fully charged.  

 

2004 Acura TSX 

2004 STARTING & CHARGING SYSTEMS Starter - TSX

  

 

Fig. 2: Starter Circuit Troubleshooting Chart 
Courtesy of AMERICAN HONDA MOTOR CO., INC.

 

2004 Acura TSX 

2004 STARTING & CHARGING SYSTEMS Starter - TSX

  

 

SYMPTOM TROUBLESHOOTING 

For symptom troubleshooting chart, see Fig. 3 . 

Fig. 3: Symptom Troubleshooting Chart 
Courtesy of AMERICAN HONDA MOTOR CO., INC. 

ON-VEHICLE TESTING 

CLUTCH INTERLOCK SWITCH TEST 

1. Disconnect the clutch interlock switch 2 pin connector (A). See Fig. 4 .  

2. Remove the clutch interlock switch (B).  

3. Check for continuity between the terminals according to the table. See Fig. 5 . If the continuity is not as 

specified, replace the clutch interlock switch. If OK, install clutch interlock switch and adjust the pedal 
height. See appropriate CLUTCHES article in TRANSAXLE/TRANSMISSION.  

 

2004 Acura TSX 

2004 STARTING & CHARGING SYSTEMS Starter - TSX