|
|
Fig. 47: Removing Internal Shaft Bearing Reassembly 1. Clean the disassembled parts with solvent, and dry them with compressed air. DO NOT wash the rubber parts with solvent. 2. Press the intermediate shaft bearing (A) into the bearing support (B) using the special tools and a press. See Fig. 49 . 3. Install, then seat the internal snap ring into the groove of the bearing support. See Fig. 46 . 4. Press the intermediate shaft (A) into the shaft bearing using attachment and a press. See Fig. 50 . 5. Install, then seat the external snap ring (A) into the groove of the intermediate shaft. See Fig. 44 . NOTE: Refer to the exploded view as needed during this procedure. See Fig. 48 .
2004 Acura TSX 2004 DRIVE AXLES Axle Shafts - Front - TSX
|