|
|
Fig. 19: Wrapping Joint Splines With Vinyl Tape Disassembly (Outboard Joint) 1. Remove the boot bands. Be careful not to damage the boot and dynamic damper. See Fig. 20 . If the boot band is an ear clamp type (B), lift up the three tabs (A) with a screwdriver. 2. Slide the outboard boot (B) partially to the inboard joint side. Be careful not to damage the boot. See Fig. 21 . 3. Wipe off the grease to expose the axle shaft and the outboard joint inner race. 4. Make a mark (A) on the axle shaft (B) at the same position of the outboard joint end (C). See Fig. 22 . 5. Carefully clamp the axle shaft in a vise. 6. Remove the outboard joint (A) using the threaded adapter and a commercially available 5/8" slide hammer (B). See Fig. 23 . 7. Remove the axle shaft from the vise. 8. Remove the stop ring from the axle shaft. See Fig. 24 .
2004 Acura TSX 2004 DRIVE AXLES Axle Shafts - Front - TSX
|