|
|
4. Disconnect the HDS from the 16P DLC. 5. Turn the ignition switch OFF, then turn it ON (II) again. 6. Test-drive the vehicle. Does the ABS indicator come on, and is DTC 68 indicated? YES: Go to step 7. NO: The system is OK at this time. 7. Troubleshoot the brake pedal position switch circuit (see CRUISE CONTROL INPUT TEST ). Is the brake pedal position switch circuit OK? YES: Substitute a known-good ECM/PCM, and recheck. z If the problem is gone, replace the original ECM/PCM. z If the problem continues, replace the VSA modulator-control unit (see VSA NO: Repair the brake pedal position switch circuit. DTC 71: DIFFERENT DIAMETER TIRE 1. Clear the DTC using the HDS (see HOW TO CLEAR DTCS ). 2. Disconnect the HDS from the 16P DLC. 3. Turn the ignition switch OFF, then turn it ON (II) again. 4. Test-drive the vehicle. Does the ABS indicator come on, and is DTC 71 indicated? YES: Go to step 5. NO: Intermittent failure; confirm that tire inflation is set to spec. The vehicle is OK at this 5. Check that all four tires are the specified size and are inflated to the proper specification. Are all four tires the correct size and properly inflated? YES: Go to step 6. NO: Install the correct tires or set the tires to the correct inflation, and retest. 6. With the vehicle on level ground, mark each tire with a small spot of grease. Roll the vehicle until each of the tires makes two grease spots on the floor. 7. Measure and record the distance between the two grease spots. Is the distance between the shortest and the longest measurement more than 10 %? YES: Replace the tire/tires that is smaller or larger than the others. NO: Replace the VSA modulator-control unit (see VSA MODULATOR-CONTROL DTC 81: CENTRAL PROCESSING UNIT (CPU) 1. Check for other DTCs. Is another DTC indicated?
2004 Acura TSX 2004 BRAKES Vehicle Stability Assist System - TSX
|