Acura TSX / Honda Accord CL. Manual - part 191

Fig. 30: Installing The Rotor In The Cam Ring & Vanes In The Grooves In The Rotor 

31. Set the 11 vanes (C) in the grooves in the rotor. Make sure that the round ends (D) of the vanes are in 

contact with the sliding surface of the cam ring.  

32. Place the side plate (A) on the cam ring, and aligning the roll pin set hole (B) in the side plate with the 

roll pin end (C). 

 

2004 Acura TSX 

2004 STEERING Power Steering System - TSX

  

 

Fig. 31: Placing The Side Plate On The Cam Ring 

33. Coat the NEW O-ring (D) with the power steering fluid, then position it into the groove on the side plate. 

34. Install the pump housing (A) over the cover assembly (B). 

 

2004 Acura TSX 

2004 STEERING Power Steering System - TSX

  

 

Fig. 32: Installing The Pump Housing Over The Cover Assembly 

35. Align the bolt holes in the cover (A) with the threaded holes in the pump housing. Install the flange bolts 

loosely first, then torque the flange bolts in a crisscross pattern in two or more steps. 

 

2004 Acura TSX 

2004 STEERING Power Steering System - TSX

  

 

Fig. 33: Aligning The Bolt Holes In The Cover With The Threaded Holes In The Pump Housing 

36. Push in the cam ring (A) from the pump housing cap hole (B) with a flat blade screwdriver, to make sure 

the cam ring is fully seated against the outer case. 

 

2004 Acura TSX 

2004 STEERING Power Steering System - TSX