Acura TSX / Honda Accord CL. Manual - part 81

Fig. 4: Locating Rear Door Components (2 Of 2) 

FRONT DOOR PANEL REMOVAL/INSTALLATION 

Special Tools Required: Trim pad remover, Snap-on A 177A or equivalent, commercially available. 

1. Lower the glass fully.  

2. Using a flat-tip screwdriver wrapped with protective tape, push on the rear hook (A) and pivot the cover 

(B) on the front hook (C), then remove the cover and the screw securing the inner handle (D). 

 

2004 Acura TSX 

2004 ACCESSORIES & EQUIPMENT Interior Trim - TSX

  

 

Fig. 5: Removing The Cover And The Screw Securing The Inner Handle 

3. Remove the power window switch panel (A). 

a. Pry up on the rear edge (driver's) or front edge (passenger's) of the switch panel with a flat-tip 

screwdriver wrapped with protective tape to release the rear clip.  

b. Pull out along the edge of the panel to release the hooks (B) and front clip.  

c. Disconnect the power mirror switch connector (C) (driver's) and the power window switch 

connector (D).  

 

2004 Acura TSX 

2004 ACCESSORIES & EQUIPMENT Interior Trim - TSX

  

 

Fig. 6: Removing The Driver's Power Window Switch Panel

 

2004 Acura TSX 

2004 ACCESSORIES & EQUIPMENT Interior Trim - TSX

  

 

Fig. 7: Removing The Passenger's Power Window Switch Panel (Driver's) 

4. Driver's: Remove the screw from under the pull pocket cap (A). 

 

2004 Acura TSX 

2004 ACCESSORIES & EQUIPMENT Interior Trim - TSX