Acura TSX / Honda Accord CL. Manual - part 63

 

  Index      Acura     Acura TSX 2004-2008 / Honda Accord CL 2006-2008 - service repair manual

 

Search            copyright infringement  

 

 

 

 

 

 

 

 

 

Content   ..  61  62  63  64   ..

 

 

Acura TSX / Honda Accord CL. Manual - part 63

 

 

Fig. 37: HDS Inputs & Commands Table (8 Of 8) 

CIRCUIT DIAGRAM 

 

2004 Acura TSX 

2004 ACCESSORIES & EQUIPMENT Multiplex Integrated Control System - TSX

  

 

Fig. 38: Multiplex Integrated Control System Wiring Diagram (1 Of 2)

 

2004 Acura TSX 

2004 ACCESSORIES & EQUIPMENT Multiplex Integrated Control System - TSX

  

 

Fig. 39: Multiplex Integrated Control System Wiring Diagram (2 Of 2) 

DTC TROUBLESHOOTING 

DTC B1000: COMMUNICATION BUS LINE ERROR 

1. Clear the DTCs using the HDS.  

2. Cycle the ignition switch to OFF and then back ON. 

 

2004 Acura TSX 

2004 ACCESSORIES & EQUIPMENT Multiplex Integrated Control System - TSX

  

 

3. Check for DTCs using the HDS. 

Is DTC B1000 indicated? 

YES: Go to step 4.  

NO: Intermittent failure. The communication bus line is OK at this time. Check for loose or 
poor connections. If the connections are good, check the battery condition and the charging 
system. See GENERATORS & REGULATORS .  

4. Check for DTCs using the HDS. 

Are DTC B1005, B1006, B1007, B1008, B1009 and B1010 indicated? 

YES: Go to step 5.  

NO: Replace the MICU.  

5. Disconnect each control unit one at a time. Clear the DTC, then recheck for DTCs after each unit is 

disconnected. 

z

Gauge control module  

z

Relay control module  

z

Driver's multiplex control unit  

z

Climate control unit  

z

Combination switch control unit 

Is DTC B1000 indicated with each unit disconnected? 

YES: Check for a short to power or ground in the communication circuit by 
disconnecting the harness at each control unit and testing for continuity to ground or 
short to power. Repair or replace the harness as necessary.  

NO: Replace the control unit that was disconnected, and did not set DTC B1000.  

DTC B1050, B1100, B1150, B1200, B1250: COMMUNICATION BUS LINE ERROR 

1. Clear the DTCs using the HDS.  

2. Cycle the ignition switch to OFF and then back ON.  

3. Check for DTCs using the HDS. 

Are DTC(s) B1050, B1100, B1150, B1200 or B1250 indicated? 

YES: Go to step 4.  

NO: Intermittent failure, the system is OK at this time. 

 

2004 Acura TSX 

2004 ACCESSORIES & EQUIPMENT Multiplex Integrated Control System - TSX

  

 

 

 

 

 

 

 

 

Content   ..  61  62  63  64   ..