Acura TSX / Honda Accord CL. Manual - part 17

Fig. 6: Cruise Control Input Tests (2 Of 2) 

CRUISE CONTROL COMBINATION SWITCH TEST/REPLACEMENT 

1. Remove the driver's airbag (see AIR BAG RESTRAINT SYSTEMS ).  

2. Remove the two screws, then disconnect the connector, and remove the switch. 

 

2004 Acura TSX 

2004 ACCESSORIES & EQUIPMENT Cruise Control - TSX

  

 

Fig. 7: Removing Cruise Control Combination Switch 

3. Check for continuity between the terminals in each switch position according to the table. 

z

If there is continuity, and it matches the table, but switch failure occurred on the cruise control unit 
input test, check and repair the wire harness on the switch circuit.  

z

If there is no continuity in one or both positions, replace the switch. 

 

2004 Acura TSX 

2004 ACCESSORIES & EQUIPMENT Cruise Control - TSX

  

 

Fig. 8: Cruise Control Combination Switch Continuity Table 

CLUTCH PEDAL POSITION SWITCH TEST 

1. Disconnect the 3P connector from the clutch pedal position switch (A). 

 

2004 Acura TSX 

2004 ACCESSORIES & EQUIPMENT Cruise Control - TSX

  

 

Fig. 9: Disconnecting The 3P Connector From The Clutch Pedal Position Switch 

2. Remove the clutch pedal position switch.  

3. Check for continuity between the terminals according to the table. 

z

If the continuity is not as specified, replace the clutch pedal position switch.  

z

If OK, install the clutch pedal position switch and adjust the pedal height (see CLUTCH PEDAL, 
CLUTCH PEDAL POSITION SWITCH, A ). 

 

2004 Acura TSX 

2004 ACCESSORIES & EQUIPMENT Cruise Control - TSX