Content .. 182 183 184 185 ..

Mazda Xedos 6. Handbuch - teil 184

Capacities

MAZDA - Xedos 6 - 2.0i V6 24V - KF

Item

Units

Values

Engine sump, incl. filter

4.2

(l)

Manual transmission

Gearbox refill

2.7

(l)

Automatic transmission

Gearbox refill

(l)

6.8

Cooling system

7.5

(l)

Air-conditioner refrigerant

(g)

700

Air-conditioner compressor oil

(ml)

175

General information

Except Xedos 9 2,3

Trouble codes are displayed by using an LED connected to the data link connector (DLC).
Except 323 1998

, 626/Estate/MX-5 1997

: Engine control module (ECM) displays all available diagnostic

information for immobilizer system.
DLC without wiring/terminals in positions FAT & TAT: Engine control module (ECM) incorporates transmission control
function.
DLC with wiring/terminals in positions FAT & TAT: Transmission control module (TCM) mounted separately.
The ECM fault memory can also be checked and erased using diagnostic equipment connected to the data link connector
(DLC).

Xedos 9 2,3

Trouble codes are displayed by using an LED connected to the data link connector (DLC).
Engine control module (ECM) displays all available diagnostic information for immobilizer system.
Transmission control module (TCM) mounted separately.
Data bus connecting ECM to TCM allows faults relating to both systems to be displayed when accessing ECM fault
memory.
The ECM/TCM fault memory can also be checked and erased using diagnostic equipment connected to the data link
connector (DLC).

Accessing

Ensure ignition switched OFF.
Bridge data link connector (DLC) terminals GND and TEN

Fig. 1

Connect LED test lamp between terminals FEN and B+

Fig. 1

NOTE: Connect LED test lamp positive connection to DLC terminal B+.

Switch ignition ON.
Count LED flashes. Note trouble codes. Compare with trouble code table.
Two digit trouble codes are displayed as follows:
Long flashes indicate the 'tens'

Fig. 2

[A].

Short flashes indicate the 'units'

Fig. 2

[C].

For example: Trouble code 12 displayed

Fig. 2

Four digit trouble codes are displayed as follows:
Each trouble code consists of four groups.
A long flash indicates the start of each group

Fig. 3

[A].

Short flashes indicate the digits of each group

Fig. 3

[B].

No short flashes in a group indicate '0'.
For example: Trouble code 0120 displayed

Fig. 3

Switch ignition OFF. Rectify faults as necessary.

Erasing

Ensure ignition switched OFF.
Disconnect battery earth lead for at least 30 seconds.
Depress brake pedal for at least 20 seconds.
Reconnect battery earth lead.
Repeat checking procedure to ensure no data remains in ECM fault memory.

WARNING: Disconnecting the battery may erase memory from electronic units (e.g. radio, clock).

Trouble code identification

Flash type

Manufacturer: Mazda

Model: Xedos 6 (CA) 2,0

Engine code: KF

Output: 103 (140) 6000

Tuned for: R-Cat

Year: 1995-00

© Autodata Limited 2004

26.03.2007

V5.500-

Flash type

2-digit

Fault location

Probable cause

Ignition pulse missing

Wiring, tachometer, ignition coil, distributor, ECM, TCM

Diesel: Engine speed (RPM) sensor - no signal

Wiring, RPM sensor

Petrol: Crankshaft position (CKP) sensor/engine
speed (RPM) sensor - no signal

Wiring, sensor supply voltage, CKP/RPM sensor

Camshaft position (CMP) sensor - no signal

Wiring, sensor supply voltage, CMP sensor

Diesel: Crankshaft position (CKP) sensor - no signal

Wiring, sensor supply voltage, CKP sensor

Petrol: Crankshaft position (CKP) sensor/engine
speed (RPM) sensor - no signal

Wiring, sensor supply voltage, CKP/RPM sensor

Knock sensor (KS)

Wiring, KS

Vehicle speed sensor (VSS)

Wiring, speedometer, VSS

Mass air flow (MAF) sensor/volume air flow (VAF)
sensor

Wiring, MAF/VAF sensor

Engine coolant temperature (ECT) sensor

Wiring, ECT sensor

Intake air temperature (IAT) sensor

Wiring, IAT sensor

Intake air temperature (IAT) sensor

Wiring, IAT sensor

Throttle position (TP) sensor

Wiring, TP sensor adjustment, TP sensor

Barometric pressure (BARO) sensor

Wiring, BARO sensor, ECM

Except V6: Oxygen sensor (O2S)/heated oxygen
sensor (HO2S) - no activity

Intake leak, fuel pressure/pump, wiring, O2S/HO2S,
injector(s), ECT sensor, MAF sensor, spark plugs

V6: Heated oxygen sensor (HO2S), bank 2 - no
activity

Intake leak, fuel pressure/pump, wiring, O2S/HO2S,
injector(s), ECT sensor, MAF sensor, spark plugs

Exhaust gas recirculation (EGR) valve position
sensor

Wiring, EGR valve position sensor

Except V6: Oxygen sensor (O2S)/heated oxygen
sensor (HO2S) - incorrect signal

Intake leak, fuel pressure/pump, wiring, O2S/HO2S,
injector(s), ECT sensor, MAF sensor, spark plugs

V6: Heated oxygen sensor (HO2S), bank 2 -
incorrect signal

Intake leak, fuel pressure/pump, wiring, O2S/HO2S,
injector(s), ECT sensor, MAF sensor, spark plugs

Fuel quantity adjuster

Wiring, fuel quantity adjuster/position sensor

Fuel quantity adjuster position sensor

Wiring, fuel quantity adjuster position sensor

Fuel shut-off solenoid

Wiring, fuel shut-off solenoid

Diesel: Fuel temperature sensor

Wiring, fuel temperature sensor

Petrol: Heated oxygen sensor (HO2S), bank 1 - no
activity

Intake leak, wiring, O2S/HO2S, injector(s), ECT sensor,
MAF sensor, spark plugs

Heated oxygen sensor (HO2S), bank 1 - incorrect
signal

Intake leak, fuel pressure/pump, wiring, O2S/HO2S,
injector(s), ECT sensor, MAF sensor, spark plugs

Fuel pressure regulator control solenoid

Wiring, fuel pressure regulator control solenoid

Evaporative emission (EVAP) canister purge valve

Wiring, EVAP canister purge valve

Exhaust gas recirculation (EGR) solenoid - vacuum

Wiring, EGR solenoid

Exhaust gas recirculation (EGR) solenoid - vent

Wiring, EGR solenoid

Idle air control (IAC) valve

Wiring, IAC valve

Fuel pressure regulator control solenoid 2

Wiring, fuel pressure regulator control solenoid

Glow plug relay

Wiring, glow plug relay

Intake manifold air control solenoid 1

Wiring, intake manifold air control solenoid

Fuel injection timing sensor

Wiring, fuel injection timing sensor/solenoid

Petrol: Intake manifold air control solenoid 2

Wiring, intake manifold air control solenoid

Diesel: Closed throttle position (CTP) switch

Wiring, CTP switch

Engine control module (ECM) - defective

ECM

Module coding plug

Wiring, module coding plug

Manufacturer: Mazda

Model: Xedos 6 (CA) 2,0

Engine code: KF

Output: 103 (140) 6000

Tuned for: R-Cat

Year: 1995-00

© Autodata Limited 2004

26.03.2007

V5.500-

Input shaft speed (ISS) sensor/turbine shaft speed
(TSS) sensor

Wiring, ISS/TSS sensor

323: Engine control module (ECM) - supply voltage

Wiring, ECM

626: Transmission fluid temperature (TFT) sensor

Wiring, TFT sensor

Engine control relay

Wiring, engine control relay

Shift solenoid (SS) A, 1-2

Wiring, SS

Shift solenoid (SS) B, 2-3

Wiring, SS

Shift solenoid (SS) C, 3-4

Wiring, SS

Torque converter clutch (TCC) control solenoid

Wiring, TCC control solenoid

Shift timing solenoid, 3-2

Wiring, shift timing solenoid

Torque converter clutch (TCC) solenoid

Wiring, TCC solenoid

Transmission fluid pressure (TFP) solenoid

Wiring, TFP solenoid

Engine coolant blower motor relay - low temperature Wiring, engine coolant blower motor relay

Engine coolant blower motor relay - high temperature Wiring, engine coolant blower motor relay

Engine coolant blower motor temperature sensor

Wiring, engine coolant blower motor temperature sensor

Engine control module (ECM)/immobilizer control
module - communication error

Wiring, immobilizer control module, ECM

Ignition key - not programmed into ECM

ECM incorrectly programmed/not programmed

Engine control module (ECM)/immobilizer control
module - immobilizer codes do not match

Incorrectly programmed immobilizer control module/ECM

Engine control module (ECM)/immobilizer control
module - ignition key codes not match

Incorrect/damaged key, ECM incorrectly programmed

Engine control module (ECM) - EEPROM error

ECM

Engine control module (ECM) - immobilizer code not
stored

ECM incorrectly/not programmed

Immobilizer control module - communication error

Incorrect/damaged key, wiring, reader coil, immobilizer
control module

P type 4-

digit

Fault location

Probable cause

Refer to EOBD trouble code table

P1100

Mass air flow (MAF) sensor - circuit intermittent

Wiring, MAF sensor

P1101

Mass air flow (MAF) sensor - circuit intermittent

Wiring, MAF sensor

P1110

Intake air temperature (IAT) sensor 2

Wiring, IAT sensor

P1112

Intake air temperature (IAT) sensor - circuit
intermittent

Wiring, IAT sensor

P1113

Intake air temperature (IAT) sensor 2

Wiring, IAT sensor

P1117

Engine coolant temperature (ECT) sensor - circuit
intermittent

Wiring, ECT sensor

P1120

Throttle position (TP) sensor - low input

Wiring short to earth, TP sensor

P1125

Throttle position (TP) sensor - circuit intermittent

Wiring, TP sensor

P1130

Fuel trim (FT) - control limit exceeded

Intake/exhaust leak, fuel pressure/pump, EVAP/EGR system,
wiring, HO2S

P1131

Heated oxygen sensor (HO2S) - low voltage

Intake/exhaust leak, fuel pressure low, hose connection,
HO2S/wiring short to earth, injector(s), MAF sensor/wiring

P1132

Heated oxygen sensor (HO2S) - high voltage

Intake/exhaust blockage, fuel pressure high, EVAP/EGR
system, HO2S/wiring short to positive, injector(s), MAF sensor

P1170

Oxygen sensor (O2S)/heated oxygen sensor
(HO2S), bank 1 - incorrect signal

Intake leak, fuel pressure/pump, wiring, O2S/HO2S, injector(s),
ECT sensor, MAF sensor, spark plugs

P1173

Oxygen sensor (O2S)/heated oxygen sensor
(HO2S), bank 2 - incorrect signal

Intake leak, fuel pressure/pump, wiring, O2S/HO2S, injector(s),
ECT sensor, MAF sensor, spark plugs

Manufacturer: Mazda

Model: Xedos 6 (CA) 2,0

Engine code: KF

Output: 103 (140) 6000

Tuned for: R-Cat

Year: 1995-00

26.03.2007

V5.500-

Content .. 182 183 184 185 ..