|
|
ENGINE 14 OVERHAUL Oil pump assembling 1. Ensure outer rotor identification marking faces outward. 2. Lubricate pump rotors with engine oil. oil. 4. Fit cover plate seal and cover plate. screws, fit and tighten screws. 6. Check that pump rotates freely. Oil pump - refit 1. Clean oil pump. scraper, remove all traces of gasket from oil 3. Clean oil seal running surface on crankshaft. crankshaft. 6. Fit oil seal protector sleeve, from seal kit, over crankshaft end. NOTE: This will assist in locating oil pump 7. Fit oil pump, fit new Patchlok bolts, M6 x 20 bolt at position 3. 8. Tighten in sequence shown to 10 Nm. |