|
|
STEERING 5 REPAIR POWER STEERING SYSTEM - BLEED Service repair no - 57.15.02 1. Ensure fluid in reservoir reaches dipstick maximum. 2. Run engine to normal operating temperature. NOTE: During instructions 4 to 6, maintain wheel. 4. With engine at idle speed, loosen bleed screw. When fluid seeps past bleed screw retighten 5. Check fluid level. for fluid leaks by holding steering on full lock in CAUTION: Do not maintain this pressure possibly damaging seals. 8. Carry out road test. POWER STEERING FLUID RESERVOIR Service repair no - 57.15.08 Remove 1. Remove undertray. 3. Loosen mounting bracket clamp bolt, raise reservoir to gain access to pipe clamps. 4. Loosen clamps, disconnect feed and return hoses from reservoir, allow fluid to drain. CAUTION: Plug the connections. 5. Remove reservoir. CAUTION: Discard fluid drained from clean area with warm water. |