|
|
04 GENERAL SPECIFICATION DATA 4 INFORMATION Front axle Type Spiral bevel, enclosed constant velocity joints, fully ................................................................................. floating shafts, 32 ° angularity of universal joint on full lock Ratio 3.54:1 ................................................................................. Propeller shafts Type, front and rear Tubular 51 mm dia. .......................................................... Universal joints Open type Hookes O3EHD ................................................................. STEERING Power steering box Make/type Adwest Varamatic - worm and roller box ........................................................................ Ratio Variable: straight ahead 19.3:1 on lock 14.3:1 ................................................................................. Steering wheel turns, lock-to-lock 3.375 .................................... Steering pump Make/type Hobourn-Eaton series 500 ........................................................................ Steering geometry Steering wheel diameter 412 mm (16.22 in) .................................................. Toe-out measurement 0 to 2 mm toe out ...................................................... Toe-out included angle 0 ° to 0 ° 20’ ..................................................... Camber angle 0 ° * .................................................................. Castor angle 3 ° * ..................................................................... Swivel pin inclination static 7 ° * ............................................... * Check with vehicle on level ground, in unladen Turning circle between kerbs 90 models: 12,65 m (41.5 ft) .............................................................. All other tyres 11,70 m (38.4 ft) ................................................................... 110 models: 13,41 m (44 ft) .................................................................. 130 models: 15,24 m (50 ft) .................................................................. |