|
|
GENERAL SPECIFICATION DATA 3 INFORMATION FUEL SYSTEM - Td5 Type Direct injection from pressure regulated supply with ................................................................................. cooled return flow Pressure regulator setting 4 bar (58 lbf.in 2 ) ................................................ Pump Electric two stage submersible ................................................................................ Pump output Low pressure 30 l/h (6.6 gal/h) at 0.5 bar (7.25 lbf.in 2 ) .......................................................... High pressure 180 l/h (39.6 gal/h) at 4 bar (58 lbf.in 2 ) .......................................................... Max consumption 30 l/h (6.6 gal/h) ............................................................. Injectors Electronic unit injectors ........................................................................... Injector normal operating pressure 1500 bar (21750 lbf.in 2 ) .................................. Filter In-line canister filter/water separator with water ................................................................................. detection COOLING SYSTEM - Td5 Type Pressurised spill return partial flow, thermostatically ................................................................................. controlled Cooling fans 11 blade axial flow on viscous coupling and 11 blade ..................................................................... axial flow electric Electric cooling fan switching points On Vehicle speeds of 50 mph (80 km/h) and below while ........................................................................... ambient temperature is 28 ° C (82 ° F) or above Off Vehicle speeds of 62.5 mph (100 km/h) and above or ........................................................................... ambient temperatures of 25 ° C (77 ° F) and below Coolant pump Centrifugal impeller, belt driven from crankshaft ................................................................... Thermostat Waxstat with pressure relief valve ....................................................................... Thermostat opening temperature Initial opening 82 ° C (179 ° F) .......................................................... Fully open 96 ° C (204 ° F) ............................................................... Expansion tank cap relief valve operating pressure 1.4 bar (20.3 lbf.in 2 ) ......... CLUTCH - Td5 Type Diaphragm spring, hydraulically operated with ................................................................................. self-centering pre-loaded release bearing Drive plate diameter 267 mm ......................................................... Pressure plate diameter 270 mm ................................................... |