Jeep Wrangler TJ. Manual - part 142

 

  Index      Jeep     Jeep Wrangler TJ - service repair manual 2005 year

 

Search            

 

 

 

 

 

 

 

 

 

Content   ..  140  141  142  143   ..

 

 

Jeep Wrangler TJ. Manual - part 142

 

 

TEST

ACTION

APPLICABILITY

3

With the DRBIII

t in Transmission Sensors, read the TPS voltage.

Is the TPS voltage below 0.5 volts?

All

Yes

→ Go To 4

No

→ Go To 6

4

Ignition on, engine not running.
With the DRBIII

t in Transmission Sensors, record the TPS voltage.

While back probing the TCM harness connector, measure the voltage of the TPS
Signal circuit.
Compare the voltage readings between the DRBIII

t and the reading from the digital

multi meter.
Are the voltages within 0.1 volt of each other?

All

Yes

→ Repair the TPS signal circuit between the TCM harness connector

and the splice for high resistance.
Perform 42RLE TRANSMISSION VERIFICATION TEST - VER
1.

No

→ Go To 5

5

Using the schematics as a guide, inspect the wiring and connectors. Repair as
necessary. Pay particular attention to all power and ground circuits.
If there are no possible causes remaining, view repair.

All

Repair

Replace the Transmission Control Module per the Service infor-
mation. WITH THE DRBIII

t PERFORM QUICK LEARN.

Perform 42RLE TRANSMISSION VERIFICATION TEST - VER
1.

6

The conditions necessary to set this DTC are not present at this time.
Using the schematics as a guide, inspect the wiring and connectors specific to this
circuit.
Wiggle the wires while checking for shorts and open circuits.
Pay particular attention to the point where the TPS signal and sensor ground circuits
splice off from the engine circuits.
With the DRBIII

t, check the EATX EVENT DATA to help identify the conditions in

which the DTC was set.
Were there any problems found?

All

Yes

→ Repair as necessary.

Perform 42RLE TRANSMISSION VERIFICATION TEST - VER
1.

No

→ Test Complete.

293

TRANSMISSION - 42RLE

P0122-THROTTLE POSITION SENSOR/APPS LOW —

Continued

Symptom:

P0123-THROTTLE POSITION SENSOR/APPS HIGH

When Monitored and Set Condition:

P0123-THROTTLE POSITION SENSOR/APPS HIGH

When Monitored:

Continuously with the ignition on and engine running.

Set Condition:

This DTC will set if the monitored TPS voltage rises above 4.94 volts for

the period of 0.48 seconds.

POSSIBLE CAUSES

ENGINE TPS DTC’S PRESENT

SENSOR GROUND CIRCUIT OPEN TO TCM

TPS SIGNAL CIRCUIT OPEN TO TCM

TRANSMISSION CONTROL MODULE

INTERMITTENT WIRING AND CONNECTORS

TEST

ACTION

APPLICABILITY

1

NOTE: Low fluid level can be the cause of many Transmission problems. If
the fluid level is low, locate and repair the leak, then check and adjust the
fluid level per the Service Information.
NOTE: Always perform diagnostics with a fully charged battery to avoid
false symptoms.
With the DRBIII

t, read the engine DTC’s. Check and repair all engine DTC’s prior

to performing Transmission Symptom Diagnostics.
With the DRBIII

t, read Transmission DTC’s. Record all DTC’s and 1 Trip Failures.

NOTE: Diagnose 1 Trip Failures as a fully matured DTC.
Using the wiring diagram/schematic as a guide, inspect the wiring and connectors.
Repair as necessary.
Perform the Shift Lever Position Test. If the test does not pass, refer to Symptom test
for P0706 Check Shifter Signal.
For Gear Ratio DTC’s, check and record all CVI’s.
Most DTC’s set on start up but some must be set by driving the vehicle such that all
diagnostic monitors have run.
NOTE: Verify flash level of Transmission Control Module. Some problems
are corrected by software upgrades to the Transmission Control Module.
NOTE: Check for applicable TSB’s related to the symptom.
Perform this procedure prior to Symptom diagnosis.

All

Continue

Go To

2

2

With the DRBIII

t, check Engine DTC’s.

Are there any Engine TPS related DTCs present?

All

Yes

→ Refer to the Powertrain category and perform the appropriate

symptom.
Perform 42RLE TRANSMISSION VERIFICATION TEST - VER
1.

No

→ Go To 3

294

TRANSMISSION - 42RLE

TEST

ACTION

APPLICABILITY

3

With the DRBIII

t in Transmission Sensors, read the TPS voltage.

Is the TPS voltage above 4.5 volts?

All

Yes

→ Go To 4

No

→ Go To 7

4

Turn the ignition off to the lock position.
Disconnect the TPS harness connector.
Disconnect the TCM harness connector.
Note: Check connectors - Clean/repair as necessary.
Measure the resistance of the TPS Signal Circuit from the TCM harness connector to
the TPS harness connector.
Is the resistance below 5.0 ohms?

All

Yes

→ Go To 5

No

→ Repair the TPS Signal circuit between the TCM harness connec-

tor and the splice for an open.
Perform 42RLE TRANSMISSION VERIFICATION TEST - VER
1.

5

Turn the ignition off to the lock position.
Disconnect the TPS harness connector.
Disconnect the TCM harness connector.
Note: Check connectors - Clean/repair as necessary.
Measure the resistance of the Sensor Ground circuit between the TPS harness
connector and the Transmission Control Module harness connector.
Is the resistance below 5.0 ohms?

All

Yes

→ Go To 6

No

→ Repair the Sensor Ground circuit between the TCM harness

connector and the splice for an open.
Perform 42RLE TRANSMISSION VERIFICATION TEST - VER
1.

6

Using the schematics as a guide, inspect the wiring and connectors. Repair as
necessary. Pay particular attention to all power and ground circuits.
If there are no possible causes remaining, view repair.

All

Repair

Replace the Transmission Control Module per the Service Infor-
mation. WITH THE DRBIII

t PERFORM QUICK LEARN.

Perform 42RLE TRANSMISSION VERIFICATION TEST - VER
1.

7

The conditions necessary to set this DTC are not present at this time.
Using the schematics as a guide, inspect the wiring and connectors specific to this
circuit.
Wiggle the wires while checking for shorts and open circuits.
Pay particular attention to the point where the TPS signal and sensor ground circuits
splice off from the engine circuits.
With the DRBIII

t, check the EATX EVENT DATA to help identify the conditions in

which the DTC was set.
Were there any problems found?

All

Yes

→ Repair as necessary.

Perform 42RLE TRANSMISSION VERIFICATION TEST - VER
1.

No

→ Test Complete.

295

TRANSMISSION - 42RLE

P0123-THROTTLE POSITION SENSOR/APPS HIGH —

Continued

Symptom:

P0124- THROTTLE POSITION SENSOR/APPS INTERMITTENT

When Monitored and Set Condition:

P0124- THROTTLE POSITION SENSOR/APPS INTERMITTENT

When Monitored:

Continuously with the ignition on and engine running.

Set Condition:

This DTC will set with a throttle angle between 6° and 120.6° with a 5° or

higher change under 7.0 milliseconds.

POSSIBLE CAUSES

ENGINE TPS DTC’S PRESENT

THROTTLE POSITION SENSOR

TRANSMISSION CONTROL MODULE

TEST

ACTION

APPLICABILITY

1

NOTE: Low fluid level can be the cause of many Transmission problems. If
the fluid level is low, locate and repair the leak, then check and adjust the
fluid level per the Service Information.
NOTE: Always perform diagnostics with a fully charged battery to avoid
false symptoms.
With the DRBIII

t, read the engine DTC’s. Check and repair all engine DTC’s prior

to performing Transmission Symptom Diagnostics.
With the DRBIII

t, read Transmission DTC’s. Record all DTC’s and 1 Trip Failures.

NOTE: Diagnose 1 Trip Failures as a fully matured DTC.
Using the wiring diagram/schematic as a guide, inspect the wiring and connectors.
Repair as necessary.
Perform the Shift Lever Position Test. If the test does not pass, refer to Symptom test
for P0706 Check Shifter Signal.
For Gear Ratio DTC’s, check and record all CVI’s.
Most DTC’s set on start up but some must be set by driving the vehicle such that all
diagnostic monitors have run.
NOTE: Verify flash level of Transmission Control Module. Some problems
are corrected by software upgrades to the Transmission Control Module.
NOTE: Check for applicable TSB’s related to the symptom.
Perform this procedure prior to Symptom diagnosis.

All

Continue

Go To

2

2

With the DRBIII

t, check Engine DTC’s.

Are any Engine TPS related DTC’s present?

All

Yes

→ Refer to the Powertrain category and perform the appropriate

symptom.
Perform 42RLE TRANSMISSION VERIFICATION TEST - VER
1.

No

→ Go To 3

296

TRANSMISSION - 42RLE

 

 

 

 

 

 

 

Content   ..  140  141  142  143   ..