|
|
P0610-AUTOMATIC TRANSMISSION CODED AS MANUAL TRANSMISSION For a complete wiring diagram Refer to Section 8W • When Monitored: • Set Condition: Possible Causes ENGINE CONTROL MODULE VERIFY ECM PROGRAMMING Diagnostic Test 1. VERIFY ECM PROGRAMMING Turn the Ignition on. With the scan tool, erase the ECM DTCs. With the scan tool, verify that the ECM is properly coded for the options and components that the vehicle is NOTE: Reprogram the ECM with correct information if necessary. With the scan tool, read ECM DTCs. Did this DTC set again? Yes >> Replace and program the Engine Control Module in accordance with the Service Information. Perform the ECM Verification Test Ver. 1 (Refer to 9 - ENGINE - DIAGNOSIS AND TESTING). No >> Test complete. Perform the ECM Verification Test Ver. 1 (Refer to 9 - ENGINE - DIAGNOSIS AND TESTING). 9 - 1098 ENGINE DIESEL DIAG KJ |