|
|
WIPER PARK SWITCH FAILURE For a complete wiring diagram Refer to Section 8W • When Monitored: • Set Condition: Possible Causes MULTIFUNCTION SWITCH FRONT WIPER MOTOR GROUND CIRCUIT OPEN FRONT WIPER MOTOR LOW DRIVER CIRCUIT OPEN FRONT WIPER MOTOR FUSED IGNITION SWITCH OUTPUT CIRCUIT Diagnostic Test 1. INTERMITTENT CONDITION Turn the ignition on. With the scan tool, erase all BCM DTC’s. Turn the Wipers on. With the scan tool, read DTCs. Does the scan tool display: WIPER PARK SWITCH FAILURE? Yes >> Go To 2 No >> The condition is not present at this time. Monitor scan tool parameters while wiggling the related wire harness. Refer to any Technical Service Bulletins that may apply. Visually inspect the related wiring har- Perform BODY VERIFICATION TEST - VER 1. 2. FRONT WIPER PARK SWITCH SENSE CIRCUIT SHORT TO VOLTAGE Turn the ignition off. Disconnect the Front Wiper Motor harness connector. Disconnect the Junction Block C3 harness connector. Turn the ignition on. Measure the voltage of the Wiper Park Switch Sense circuit in the Front Wiper Motor harness connector. Is there any voltage present? Yes >> Repair the Wiper Park Switch Sense circuit for a short to voltage. Perform BODY VERIFICATION TEST - VER 1. No >> Go To 3 8R - 20 WIPERS/WASHERS ELECTRICAL DIAGNOSTICS KJ |