|
|
B210E–BATTERY VOLTAGE HIGH – MEMORY MIRROR MODULE For the Power Memory Mirror System circuit diagram (Refer to 8 - ELECTRICAL/POWER MIRRORS - SCHEMAT- For a complete wiring diagram Refer to Section 8W. • When Monitored: • Set Condition: POSSIBLE CAUSES BATTERY / CHARGING SYSTEM DRIVER MEMORY MIRROR MODULE PASSENGER MEMORY MIRROR MODULE NOTE: Since this DTC can set in the Driver Door Module (DDM) and in the Passenger Door Module (PDM) Diagnostic Test 1. CHECK FOR ENGINE DTCs Turn the ignition on. With the scan tool, read engine DTCs. Does the scan tool display any BATTERY VOLTAGE HIGH related DTCs? Yes >> Diagnose and repair the DTC(s). (Refer to 9 - ENGINE - DIAGNOSIS AND TESTING) for the diagnostic test procedure(s). No >> If DTC B210E BATTERY VOLTAGE HIGH set in the Driver Door Module (DDM), Go To 2. If DTC B210E BATTERY VOLTAGE HIGH set in the Passenger Door Module (PDM), Go To 3 2. TEST FOR INTERMITTENT CONDITION – DDM With the scan tool, erase DTCs Start the engine and run for 2 minutes. Cycle the ignition from on to off 3 times. Turn the ignition on. With the scan tool, read Driver Door Module (DDM) DTCs. Does the scan tool display: B210E–BATTERY VOLTAGE HIGH? Yes >> Replace the Driver Memory Mirror Module in accordance with the Service Information. Perform BODY VERIFICATION TEST – VER 1. (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL No >> The conditions that caused this code to set are not present at this time. Perform BODY VERIFICATION TEST – VER 1. (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL 8N - 196 POWER MIRRORS - ELECTRICAL DIAGNOSTICS WK |