|
|
B168F-FRONT FOG LAMP SWITCH STUCK (SCM) For a complete wiring diagram Refer to Section 8W. • When Monitored: • Set Condition: Possible Causes LIGHTING MULTIFUNCTION SWITCH STEERING CONTROL MODULE Diagnostic Test 1. TEST FOR INTERMITTENT CONDITION With the scan tool, record and erase DTC’s Operate the Fog Lamp Switch several times. Turn the ignition on and wait 30 seconds. With the scan tool, read DTC’s. Does the scan tool display: B168F-FRONT FOG LAMP SWITCH STUCK? Yes >> Go To 2 No >> The conditions that caused this code to set are not present at this time. Using the wiring diagram/sche- matic as a guide, inspect the wiring and connectors. Perform BODY VERIFICATION TEST - VER 1. (Refer to BODY VERIFICATION TEST – VER 1. 2. LIGHTING MULTIFUNCTION SWITCH Turn the ignition off. Using the correct service procedure, remove the Lighting Multi-Function Switch. Measure the internal resistance of the Multifunction Switch between cavities 4 and 5. Move the switch position from OFF = OPEN OFF WITH FOG = 1047 ohms PARK WITH FOG = 383 ohms HEAD WITH FOG = 173 ohms AUTO WITH FOG = 0 ohms Is the resistance in each position correct? Yes >> Replace the Steering Control Module in accordance with the service information. Perform the BODY VERIFICATION TEST — VER 1. (Refer to 8 - ELECTRICAL/ELECTRONIC CON- No >> Replace the Multifunction Switch in accordance with the service information. Perform the BODY VERIFICATION TEST — VER 1. (Refer to 8 - ELECTRICAL/ELECTRONIC CON- 8L - 70 LAMPS/LIGHTING - EXTERIOR - ELECTRICAL DIAGNOSTICS WK |