Jeep Grand Cherokee WK. Manual - part 171

 

  Index      Jeep     Jeep Grand Cherokee WK - service repair manual 2005 year

 

Search            

 

 

 

 

 

 

 

 

 

Content   ..  169  170  171  172   ..

 

 

Jeep Grand Cherokee WK. Manual - part 171

 

 

C123A-ESP SYSTEM SENSORS CALIBRATION

5 - 310

BRAKES - BRAKE CONTROLLER ELECTRICAL DIAGNOSTICS

WK

C123A-ESP SYSTEM SENSORS CALIBRATION (CONTINUED)

For the Anti-Lock Brake System circuit diagram. (Refer to 5 - BRAKES - SCHEMATICS AND DIAGRAMS)

For a complete wiring diagram Refer to Section 8W.

When Monitored:
With the ignition on.

Set Condition:
When the Anti-Lock Brake Module indicates the Dynamics Sensor stored calibration values are invalid.

Possible Causes

WIRING HARNESS, TERMINAL, CONNECTOR DAMAGE

DYNAMICS SENSOR

ANTI-LOCK BRAKE MODULE

Diagnostic Test

1.

CHECK FOR A DTC C123A-ESP SYSTEM SENSORS CALIBRATION

NOTE: This DTC must be active for the results of this test to be valid.
Turn the ignition on.

With the scan tool, read and record DTC’s.

With the scan tool, read and record Freeze Fame information.

With the scan tool, erase DTC’s.

Cycle the ignition switch from off to on.

With the scan tool, read and record DTC’s

Does the scan tool display: C123A-ESP SYSTEM SENSORS CALIBRATION?

Yes

>> Go To 2

No

>> Refer to the INTERMITTENT CONDITION diagnostic procedure.

Perform ABS VERIFICATION TEST - VER 1.

2.

CHECK THE WIRING HARNESS, TERMINALS, AND CONNECTORS

Visually inspect the related wiring harness. Look for any bruised, chafed, pierced, or partially broken wires.

Visually inspect the related wiring harness connectors. Look for broken, bent, pushed out, or corroded terminals.

Were any problems found?

Yes

>> Repair as necessary.

Perform ABS VERIFICATION TEST - VER 1.

No

>> Go To 3

WK

BRAKES - BRAKE CONTROLLER ELECTRICAL DIAGNOSTICS

5 - 311

C123A-ESP SYSTEM SENSORS CALIBRATION (CONTINUED)

3.

CHECK THE DYNAMICS SENSOR OUTPUT

CAUTION: Ensure brake capability is available before road testing.
Have an assistant test drive the vehicle while monitoring the Dynamics Sensor operation.

Was the Lateral Sensor output between 0.02 G to 0.16 G and the Yaw Sensor between 1.30° to 5.70°?

Yes

>> Replace the Anti-Lock Brake Module in accordance with the Service Information.

Perform ABS VERIFICATION TEST - VER 1.

No

>> Replace the Dynamics Sensor in accordance with the Service Information.

Perform ABS VERIFICATION TEST - VER 1.

5 - 312

BRAKES - BRAKE CONTROLLER ELECTRICAL DIAGNOSTICS

WK

C123B-ESP SYSTEM CONTROL TOO LONG

WK

BRAKES - BRAKE CONTROLLER ELECTRICAL DIAGNOSTICS

5 - 313

 

 

 

 

 

 

 

Content   ..  169  170  171  172   ..