|
|
VDC WARNING LAMP BRC-125 < DTC/CIRCUIT DIAGNOSIS > [WITH VDC] C D E G H I J K L M A B BRC N O P VDC WARNING LAMP Component Function Check INFOID:0000000006222653 1. CHECK VDC WARNING LAMP FUNCTION Check that VDC warning lamp in combination meter turns ON for approx. 1 second after ignition switch is CAUTION: Never start engine. YES >> INSPECTION END NO >> Proceed to diagnosis procedure. Refer to BRC-125, "Diagnosis Procedure" Diagnosis Procedure INFOID:0000000006222654 1. CHECK ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT) POWER SUPPLY AND GROUND CIR- CUIT Perform the trouble diagnosis for ABS actuator and electric unit (control unit) power supply and ground circuit. BRC-113, "Diagnosis Procedure" . Is the inspection result normal? YES >> GO TO 2. NO >> Repair or replace error-detected parts. 2. PERFORM THE SELF-DIAGNOSIS With CONSULT-III. Perform self-diagnosis for “ABS”. YES >> Check the DTC. Refer to . NO >> GO TO 3. 3. CHECK VDC WARNING LAMP SIGNAL With CONSULT-III. 1. Select “ABS”, “DATA MONITOR” and “SLIP/VDC LAMP” according to this order. 2. Turn the ignition switch OFF. 3. Check that data monitor displays “On” for approx. 1 second after ignition switch is turned ON and then CAUTION: Never start engine. Is the inspection result normal? YES >> GO TO 4. NO >> Replace ABS actuator and electric unit (control unit). Refer to BRC-137, "Removal and Installa- . 4. CHECK COMBINATION METER Check combination meter. Refer to MWI-30, "CONSULT-III Function" . Is the inspection result normal? YES >> Replace ABS actuator and electric unit (control unit). Refer to BRC-137, "Removal and Installa- . NO >> Repair or replace combination meter. Refer to |