|
|
TROUBLE DIAGNOSIS AT-57 D E F G H I J K L M A B AT Cruise Test - Part 1 NCS000UE 1. CHECK STARTING OUT FROM D1 1. Drive the vehicle for about 10 minutes to warm up the engine oil and ATF. ° C (122 to 176 ° F) 2. Park the vehicle on a level surface. 3. Move selector lever to “P” position. 4. Start engine. 5. Move selector lever to “D” position. 6. Press the accelerator pedal about half-way down to accelerate the vehicle. With CONSULT-II Read the gear position. Refer to . Starts from D1? YES >> GO TO 2. NO >> Enter a check mark at “Vehicle Cannot Be Started from D1” on the , then continue the road test. 2. CHECK SHIFT-UP D1 → D2 Press down the accelerator pedal about half-way and inspect if the vehicle shifts up (D1 → D2) at the appro- AT-60, "Vehicle Speed at Which Gear Shifting Occurs" . With CONSULT-II Read the gear position, throttle degree of opening, and vehicle speed. Refer to . Does the A/T shift-up D1 → D2 at the correct speed? YES >> GO TO 3. NO >> Enter a check mark at “A/T Does Not Shift: D1 → D2” on the , then continue the road test. 3. CHECK SHIFT-UP D2 → D3 Press down the accelerator pedal about half-way and inspect if the vehicle shifts up (D2 → D3) at the appro- AT-60, "Vehicle Speed at Which Gear Shifting Occurs" . With CONSULT-II Read the gear position, throttle degree of opening, and vehicle speed. Refer to . Does the A/T shift-up D2 → D3 at the correct speed? YES >> GO TO 4. NO >> Enter a check mark at “A/T Does Not Shift: D2 → D3” on the , then continue the road test. 4. CHECK SHIFT-UP D3 → D4 Press down the accelerator pedal about half-way and inspect if the vehicle shifts up (D3 → D4) at the appro- AT-60, "Vehicle Speed at Which Gear Shifting Occurs" . With CONSULT-II Read the gear position, throttle degree of opening, and vehicle speed. Refer to . Does the A/T shift-up D3 → D4 at the correct speed? YES >> GO TO 5. NO >> Enter a check mark at “A/T Does Not Shift: D3 → D4” on the , then continue the road test. |