|
|
FUEL TANK FL-11 C D E F G H I J K L M A FL 7. Disconnect fuel filler hose, vent hose and EVAP hoses at fuel 8. Support the lower part of fuel tank with transmission jack. CAUTION: Support the position that fuel tank mounting bands do not 9. Remove fuel tank mounting bands. 10. Supporting with hands, descend transmission jack carefully, and remove fuel tank. CAUTION: ● Make sure that all connection points have been disconnected. ● Confirm there is no interference with vehicle. 11. Remove fuel filler tube, as necessary. INSTALLATION Note the following, and install in the reverse order of removal. ● Surely clamp fuel hoses and insert hose to the length below. ● Be sure hose clamp is not placed on swelled area of fuel tube. ● Tighten the clamp hand with the top mark until the mark is on the ● To connect quick connector, refer to INSPECTION AFTER INSTALLATION Use the following procedure to check for fuel leaks. 1. Turn ignition switch “ON” (with engine stopped), and check connections for leakage by applying fuel pres- PBIC1581E PBIC0878E Fuel filler hose : 35 mm (1.38 in) The other hoses : 25 mm (0.98 in) PBIC3388E |