|
|
DTC P0137, P0157 HO2S2 EC-997 [VK45DE] C D E F G H I J K L M A EC ● Before installing new oxygen sensor, clean exhaust system threads using Oxygen Sensor Thread Without CONSULT-II 1. Start engine and warm it up to the normal operating temperature. 2. Turn ignition switch OFF and wait at least 10 seconds. 3. Start engine and keep the engine speed between 3,500 and 4,000 rpm for at least 1 minute under no load. 4. Let engine idle for 1 minute. 5. Set voltmeter probes between ECM terminal 55 [HO2S2 (B1) signal] or 74 [HO2S2 (B2) signal] and 6. Check the voltage when revving up to 4,000 rpm under no load 7. Keep vehicle at idling for 10 minutes, then check voltage. Or 8. If NG, replace heated oxygen sensor 2. CAUTION: ● Discard any heated oxygen sensor which has been dropped from a height of more than 0.5 m (19.7 ● Before installing new oxygen sensor, clean exhaust system threads using Oxygen Sensor Thread Removal and Installation NBS005EQ HEATED OXYGEN SENSOR 2 Refer to PBIB2054E |