|
|
CCS C1A05 BRAKE SW/STOP LAMP SW CCS-39 < COMPONENT DIAGNOSIS > [INTELLIGENT CRUISE CONTROL] C D E F G H I J K L M B N P A >> GO TO 27. 26. REPLACE ICC SENSOR INTEGRATED UNIT 1. Replace ICC sensor integrated unit. 2. Adjust laser beam aiming. Refer to CCS-7, "LASER BEAM AIMING ADJUSTMENT : Special Repair . >> GO TO 27. 27. CHECK ICC SYSTEM 1. Erase DTC and perform ICC system action test. Then perform self-diagnosis of ICC sensor integrated CCS-11, "ACTION TEST : Special Repair Requirement (Vehicle-To-Vehicle Distance Control Mode)" ). 2. Check that no abnormal condition is present in the ICC system. >> INSPECTION END Diagnosis Procedure (M/T Models) INFOID:0000000000965410 1. PERFORM SELF-DIAGNOSIS OF ICC SENSOR INTEGRATED UNIT 1. Perform self-diagnosis of ICC sensor integrated unit. 2. Check if DTC “CAN COMM CIRCUIT [U1000]” (DTC 100), “ECM CAN CIR 1 [U0401]” (DTC 120), “VDC Is any DTC detected? YES >> GO TO 2. NO >> GO TO 3. 2. DIAGNOSIS FOR DETECTED DTC Perform diagnosis on the detected DTC and repair or replace the applicable item. Refer to . >> GO TO 33. 3. CHECK ICC BRAKE SWITCH WITH ICC DATA MONITOR With CONSULT-III With “DATA MONITOR” of “ICC”, check if “BRAKE SW” operates normally. Is the inspection result normal? YES >> GO TO 4. NO >> GO TO 7. 4. CHECK STOP LAMP SWITCH WITH ABS DATA MONITOR With CONSULT-III With “DATA MONITOR” of “ABS”, check if “STOP LAMP SW” operates normally. Is the inspection result normal? YES >> GO TO 5. NO >> GO TO 22. 5. PERFORM SELF-DIAGNOSIS OF ECM 1. Perform self-diagnosis of ECM. 2. Check if DTC is detected. Refer to . Is any DTC detected? YES >> GO TO 31. NO >> GO TO 6. 6. PERFORM SELF-DIAGNOSIS OF ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT) |