Infiniti FX35 / FX45. Manual - part 614

EI-20

< SERVICE INFORMATION >

REAR BUMPER

3.

Remove rear reflex reflector assembly screw and remove rear
reflex reflector assembly.

Assembly

Assemble in the reverse order of disassembly.

REMOVAL AND INSTALLATION OF REAR BUMPER CLOSING

Removal

Remove clips of bumper closing and remove rear bumper closing.

Installation

Install in the reverse order of removal.

REMOVAL AND INSTALLATION OF DRAFTER GUARD

Removal

Remove clips and bolt of drafter guard and remove drafter guard.

Installation

Install in the reverse order of removal.

REMOVAL AND INSTALLATION OF REAR FILLET MOLDING ASSEMBLY

Removal 

PIIA6417E

PIIA4954E

PIIA4955E

REAR BUMPER

EI-21

< SERVICE INFORMATION >

C

D

E

F

G

H

J

K

L

M

A

B

EI

N

O

P

1.

Remove bolts of fillet molding assembly.

2.

Remove clips of fillet molding assembly.

3.

Remove fillet molding assembly.

Installation

1.

Clean adhesive portion of rear fender with white gasoline.

2.

Strip pattern from the new double adhesive tape and paste on rear fender.

3.

Fillet molding assembly hold with rear fender.

PIIA4347E

EI-22

< SERVICE INFORMATION >

FRONT GRILLE

FRONT GRILLE

Component Parts Location

INFOID:0000000001328062

Removal and Installation

INFOID:0000000001529397

CAUTION:

Apply protection tape around outer circumference of front grille (bumper fascia side).

REMOVAL

1.

Remove turn fastener of grille. 

2.

Remove clips on upper side of grille.

3.

Pull out grille pawls, and remove grille assembly.

INSTALLATION

Install in the reverse order of removal.

1.

Front grille

2.

Turn fastener (CG101)

3.

Clip (C205)

4.

Front bumper fascia

PIIA4349E

COWL TOP

EI-23

< SERVICE INFORMATION >

C

D

E

F

G

H

J

K

L

M

A

B

EI

N

O

P

COWL TOP

Component Parts Location

INFOID:0000000001328063

Removal and Installation

INFOID:0000000001529398

REMOVAL

1.

Remove clips of hood ledge cover and remove hood ledge cover.

2.

Remove wiper arms (RH/LH). Refer to 

WW-23, "Removal and Installation of Front Wiper Arms, Adjust-

ment of Wiper Arms Stop Location"

.

3.

Remove cowl top seal rubber.

4.

Remove clips of cowl top cover (RH) and remove cowl top cover (RH).

5.

Remove clips, cap and bolts and remove cowl top cover (LH).

6.

Remove washer hose from cowl top cover.

INSTALLATION

Install in the reverse order of removal.

CAUTION:

• When installing cowl top cover, make sure that blind clips are securely fitted in panel holes on body,

and then press them in.

• After installing, perform adjustment of wiper arms. Refer to 

WW-23, "Removal and Installation of

Front Wiper Arms, Adjustment of Wiper Arms Stop Location"

. 

1.

Cowl top cover (RH)

2.

Clip (C205)

3.

Hood ledge cover (RH)

4.

Cowl top seal rubber

5.

Hood ledge cover (LH)

6.

Bolt

7.

Cap

8.

Cowl top cover (LH)

PIIA4946E