|
|
EM-164 < PERIODIC MAINTENANCE > [VK50VE] DRIVE BELTS Tension Adjustment INFOID:0000000005245210 Removal and Installation INFOID:0000000005245211 REMOVAL Alternator, Water Pump and A/C Compressor Belt 1. Remove air duct (inlet). Refer to . 2. Remove reservoir tank. Refer to . 3. With box wrench, and while securely holding the hexagonal part CAUTION: • Never place hand in a location where pinching may occur if the holding tool accidentally comes off. • Never loosen the hexagonal part in center of auto ten- sioner pulley (Never turn it clockwise). If turned clock- 4. Under the above condition, insert a metallic bar (A) of approxi- 5. Remove alternator, water pump and A/C compressor belt. Power Steering Oil Pump Belt 1. Remove engine undercover with power tool. 2. Remove alternator, water pump and A/C compressor belt. Refer to "Alternator, Water Pump and A/C 3. With box wrench, and while securely holding the hexagonal part CAUTION: • Never place hand in a location where pinching may occur if the holding tool accidentally comes off. • Never loosen the hexagonal part in center of auto ten- sioner pulley (Never turn it clockwise). If turned clock- 4. Under the above condition, insert a metallic bar (A) of approxi- 5. Remove power steering oil pump belt. INSTALLATION Note the following item, and install in the reverse order of removal. CAUTION: • Check drive belts are securely installed around all pulleys. Inspection INFOID:0000000005245212 INSPECTION AFTER INSTALLATION JPBIA2328ZZ JPBIA2327ZZ |