Infiniti FX35, FX50 (S51). Manual - part 761
INSPECTION AND ADJUSTMENT
EC-585
< BASIC INSPECTION >
[VK50VE]
C
D
E
F
G
H
I
J
K
L
M
A
EC
N
P
O
7.
Loosen the VVEL control shaft position sensor mounting bolts
(1).
8.
Turn the VVEL control shaft position sensor (2) clockwise and
counterclockwise while monitoring the output voltage between
the VVEL control module terminals with a tester and adjust the
output voltage to be within the standard value.
9.
Tighten the VVEL control shaft position sensor mounting bolts.
10. Reconfirm that the output voltage of VVEL control shaft position sensor is within the standard value.
NOTE:
If it varies from the standard value after the mounting bolts are tightened, perform steps 7 to 9 again.
11. Turn ignition switch OFF and wait at least 10 seconds.
12. Start engine and warm it up to normal operating temperature.
13. Turn ignition switch OFF and wait at least 10 seconds.
14. Perform Idle Air Volume Learning. Refer to
EC-582, "IDLE AIR VOLUME LEARNING : Special Repair
.
>> INSPECTION END
MIXTURE RATIO SELF-LEARNING VALUE CLEAR
MIXTURE RATIO SELF-LEARNING VALUE CLEAR : Description
INFOID:0000000005237166
This describes how to erase the mixture ratio self-learning value. For the actual procedure, follow the instruc-
tions in “Diagnosis Procedure”.
MIXTURE RATIO SELF-LEARNING VALUE CLEAR : Special Repair Requirement
INFOID:0000000005237167
1.
START
With CONSULT-III
1.
Start engine and warm it up to normal operating temperature.
2.
Select “SELF-LEARNING CONT” in “WORK SUPPORT” mode with CONSULT-III.
3.
Clear mixture ratio self-learning value by touching “CLEAR”.
With GST
1.
Start engine and warm it up to normal operating temperature.
JMBIA1557ZZ
VVEL control module
Voltage
Bank
Connector
+
–
Terminal
Terminal
1
E16
3
6
500
±
48 mV
2
5
4
:
7.0 N•m (0.71 kg-m, 62 in-lb)
VVEL control module
Voltage
Bank
Connector
+
–
Terminal
Terminal
1
E16
3 6
500
±
48 mV
2
5
4