|
|
DIFFERENTIAL ASSEMBLY DLN-231 < UNIT DISASSEMBLY AND ASSEMBLY > [REAR FINAL DRIVE: R200] C E F G H I J K L M A B DLN N O P 15. Align matching marks on bearing cap with that on gear carrier. 16. Install bearing caps and tighten bearing cap mounting bolts. 17. Using the drift (A) [SST: KV38100200 (J-26233)], drive side oil seals until it becomes flush with the case end. CAUTION: • Never reuse oil seal. onto the circumference of oil seal. 18. Check and adjust drive gear runout, tooth contact, drive gear to drive pinion backlash, and total preload torque. Refer to Recheck above items. Readjust the above description, if neces- 19. Apply sealant (A) to mating surface of rear cover. • Use Genuine Silicone RTV or equivalent. Refer to "Recommended Chemical Products and Sealants" . CAUTION: Remove old sealant adhering to mounting surfaces. Also 20. Install rear cover on gear carrier and tighten mounting bolts. 21. Install side flange with the following procedure. a. Attach the protector [SST: KV38107900 (J-39352)] to side oil b. After the side flange is inserted and the serrated part of side c. Put a suitable drift on the center of side flange, then drive it until sound changes. SDIA1795E SPD560 PDIA0961E SDIA0822E |