|
|
CCS-228 < DTC/CIRCUIT DIAGNOSIS > [DCA] C1A08 PRESSURE SENSOR Is the inspection result normal? YES >> GO TO 3. NO >> Repair the harnesses or connectors. 3. CHECK BRAKE PRESSURE SENSOR POWER SUPPLY CIRCUIT 1. Connect connectors of brake booster control unit and brake pressure sensor. 2. Turn the ignition switch ON. 3. Check voltage between brake booster control unit harness connectors. Is the inspection result normal? YES >> Replace the brake pressure sensor. NO >> Replace the brake booster control unit. Special Repair Requirement INFOID:0000000005501810 DESCRIPTION Perform the action test after adjusting the laser beam aiming of ICC sensor integrated unit when the following SPECIAL REPAIR REQUIREMENT 1. LASER BEAM AIMING ADJUSTMENT OF ICC SENSOR INTEGRATED UNIT Adjust the laser beam aiming of the ICC sensor integrated unit. Refer to >> GO TO 2. 2. CHECK DCA SYSTEM 1. Erase the “self-diagnosis results”, and then perform “All DTC Reading” again after performing the action CCS-191, "ACTION TEST : Description" for action test.) 2. Check that the DCA system is normal. >> WORK END Brake booster control unit Ground Continuity Connector Terminal B250 8 Not existed 17 24 Terminals Voltage (Approx.) (+) (–) Brake booster control unit Connector Terminal B250 8 24 5 V |