|
|
PRECAUTIONS BR-5 < PRECAUTION > C D E G H I J K L M A B BR N O P 5. When the repair work is completed, re-connect both battery cables. With the brake pedal released, turn 6. Perform self-diagnosis check of all control units using CONSULT-III. Precaution for Procedure without Cowl Top Cover INFOID:0000000005234160 When performing the procedure after removing cowl top cover, cover Precaution for Brake System INFOID:0000000005234161 WARNING: Clean any dust from the front brake and rear brake with a vacuum dust collector. Never blow with com- CAUTION: • Brake fluid use refer to MA-12, "Fluids and Lubricants" • Never reuse drained brake fluid. off immediately and wash with water if it gets on a painted surface. • After pressing the brake pedal more deeply or harder than normal driving, such as air bleeding, check each item of brake pedal. Adjust brake pedal if it is outside the standard value. • Always clean with new brake fluid when cleaning the master cylinder, brake caliper and other com- ponents. • Never use mineral oils such as gasoline or light oil to clean. They may damage rubber parts and cause improper operation. • Always loosen the brake tube flare nut with a flare nut wrench. crowfoot (A) and torque wrench (B). • Always confirm the specified tightening torque when install- ing the brake pipes. • Turn the ignition switch OFF and disconnect the ABS actuator and electric unit (control unit) connector or the battery nega- • Check that no brake fluid leakage is present after replacing the parts. • Burnish the brake contact surfaces after refinishing or replac- ing rotors, after replacing pads, or if a soft pedal occurs at - Front brake pad: refer to BR-14, "BRAKE PAD : Inspection and Adjustment" - Front disc rotor: refer to BR-14, "DISC ROTOR : Inspection and Adjustment" - Rear brake pad: refer to BR-16, "BRAKE PAD : Inspection and Adjustment" - Rear disc rotor: refer to BR-16, "DISC ROTOR : Inspection and Adjustment" . PIIB3706J JPFIA0001ZZ |