|
|
Content .. 1611 1612 1613 1614 ..
C1D14 SHOCK ABSORBER ACTUATOR SCS-37 < DTC/CIRCUIT DIAGNOSIS > C D F G H I J K L M A B SCS N O P 3. CHECK REAR RH SHOCK ABSORBER ACTUATOR Perform the rear RH shock absorber actuator. Refer to SCS-37, "Component Inspection" . Is the inspection result normal? YES >> GO TO 4. NO >> Replace the rear RH shock absorber. Refer to . 4. PERFORM DATA MONITOR With CONSULT-III 1. Start the engine. 2. Select “DATA MONITOR” of “E-SUS”. 3. Select “RR ACTUATOR CRNT” of “DATA MONITOR” screen. 4. Drive the vehicle and check whether it is within the following range. Is the inspection result normal? YES >> Check pin terminal and connection of each harness connector for damage or loose connections. Repair or replace error-detected parts. NO >> Replace E-SUS control unit. Refer to Component Inspection INFOID:0000000005588947 1. PERFORM ACTIVE TEST With CONSULT-III 1. Connect the E-SUS control unit harness connector and rear RH shock absorber actuator harness connec- 2. Select “REAR RIGHT ACTUATOR” in “ACTIVE TEST”. 3. On the display, change the “Operation half cycle”, and check that the operation noise is heard from the Is the inspection result normal? YES >> INSPECTION END NO >> Replace the rear RH wheel shock absorber. Refer to RR ACTUATOR CRNT : Approx. 0.65 – 2.0 A Test item Display Item Display Operation half cycle SHOCK ABSORBER ACTUATOR REAR RIGHT ACTUATOR 0.1 seconds – 1 second (cycle in 0.1 seconds) |