|
|
Content .. 1571 1572 1573 1574 ..
GLASS LID RF-73 < REMOVAL AND INSTALLATION > C D E F G H I J L M A B RF N O P 1. Remove the inner blind. 2. Remove the TORX bolts (A). 3. Remove the glass lid from the vehicle. INSTALLATION CAUTION: After installing the glass lid, perform the leak test and check that there is no malfunction. Install in the reverse order of removal. Adjustment INFOID:0000000005248646 LID WEATHER-STRIP OVERLAP ADJUSTMENT AND SURFACE MISMATCH ADJUSTMENT 1. Tilt up glass lid, and then remove lnner blind (left and right). 2. After loosening glass lid from TORX bolts (left and right), tilt down glass lid. 3. Adjust glass lid from outside of vehicle so it resembles “A – A” “B – B” “C – C” as shown in the figure. 4. To prevent glass lid from moving after adjustment, first tighten the TORX bolts of front left, and then 5. Tighten remaining TORX bolts, being careful to prevent glass lid from moving. 6. Tilt glass lid up and down several times to check that it moves smoothly. NOTE: JMKIA2690ZZ PIIB3117J Portion a (Wether-strip overlap) b (Surface height) Glass lid front end A – A 0.6 – 2.2 mm (0.024 – 0.087 in) − 0.7 – 2.3 mm ( − 0.028 – 0.091 in) Glass lid side end B – B 0.6 – 2.2 mm (0.024 – 0.087 in) − 0.7 – 2.3 mm ( − 0.028 – 0.091 in) Glass lid rear end C – C 0.6 – 2.2 mm (0.024 – 0.087 in) − 0.7 – 2.3 mm ( − 0.028 – 0.091 in) |