|
|
Content .. 1340 1341 1342 1343 ..
LAN-310 < DTC/CIRCUIT DIAGNOSIS > [CAN SYSTEM (TYPE 9)] CAN COMMUNICATION CIRCUIT 2 Non-reproduced>>Start the diagnosis again. Follow the trouble diagnosis procedure when past error is detected. 6. CHECK UNIT REPRODUCTION Perform the reproduction test as per the following procedure for each unit. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Disconnect one of the unit connectors of CAN communication circuit 2. 4. Connect the battery cable to the negative terminal. Check if the symptoms described in the “Symptom Inspection result Reproduced>>Connect the connector. Check other units as per the above procedure. |