|
|
Content .. 1103 1104 1105 1106 ..
PRECAUTIONS GI-21 < PRECAUTION > C D E F G H I J K L M B GI N O P PRECAUTION PRECAUTIONS Description INFOID:0000000005248677 Observe the following precautions to ensure safe and proper servicing. These precautions are not Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT INFOID:0000000005248678 The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along WARNING: • To avoid rendering the SRS inoperative, which could increase the risk of personal injury or death in the event of a collision which would result in air bag inflation, all maintenance must be performed by • Improper maintenance, including incorrect removal and installation of the SRS, can lead to personal injury caused by unintentional activation of the system. For removal of Spiral Cable and Air Bag • Do not use electrical test equipment on any circuit related to the SRS unless instructed to in this Service Manual. SRS wiring harnesses can be identified by yellow and/or orange harnesses or har- PRECAUTIONS WHEN USING POWER TOOLS (AIR OR ELECTRIC) AND HAMMERS WARNING: • When working near the Air Bag Diagnosis Sensor Unit or other Air Bag System sensors with the ignition ON or engine running, DO NOT use air or electric power tools or strike near the sensor(s) • When using air or electric power tools or hammers, always switch the ignition OFF, disconnect the battery, and wait at least 3 minutes before performing any service. Precautions For Xenon Headlamp Service INFOID:0000000005248679 WARNING: Comply with the following warnings to prevent any serious accident. ing, or touching the xenon headlamp (bulb included). The xenon headlamp contains high-voltage • Never work with wet hands. headlamp ON in other conditions. Connect the power supply to the vehicle-side connector. • Never touch the bulb glass immediately after turning it OFF. It is extremely hot. CAUTION: Comply with the following cautions to prevent any error and malfunction. tor, the housing, etc. by high-voltage leakage or corona discharge.) • Never perform HID circuit inspection with a tester. |