|
|
Content .. 1084 1085 1086 1087 ..
FL-6 < REMOVAL AND INSTALLATION > FUEL LEVEL SENSOR UNIT, FUEL FILTER AND FUEL PUMP ASSEMBLY a. Insert hose of less than 25 mm (0.98 in) in diameter into fuel filler tube through fuel filler opening to draw b. Disconnect fuel filler hose from fuel filler tube. Refer to c. Insert fuel tube into fuel tank through fuel filler hose to draw fuel from fuel tank. 2. Release the fuel pressure from the fuel lines. Refer to (VQ35HR) or 3. Open fuel filler lid. 4. Open filler cap and release the pressure inside fuel tank. 5. Remove rear seat cushion. Refer to . 6. Peel off floor carpet, then remove inspection hole cover (1) units 7. Disconnect harness connector (3) and fuel feed tube (2). Disconnect quick connector as follows: • Hold the sides of connector, push in tabs and pull out fuel feed tube. • If quick connector sticks to tube of main fuel level sensor unit, push and pull quick connector several times until they start to CAUTION: A : Direction mark b : 90 ° : Vehicle front Right side : Main fuel level sensor unit, fuel filter Left side : Sub fuel level sensor unit JPBIA0132ZZ 1 : Quick connector : Vehicle front JPBIA0133ZZ A : Pull B : Push in tabs JPBIA0134ZZ |