|
|
FAX-6 < ON-VEHICLE REPAIR > [2WD] FRONT WHEEL HUB AND KNUCKLE ON-VEHICLE REPAIR FRONT WHEEL HUB AND KNUCKLE Exploded View INFOID:0000000003138925 Removal and Installation INFOID:0000000003138926 REMOVAL 1. Remove tires with power tool. 2. Remove wheel sensor and sensor harness. Refer to BRC-107, "FRONT WHEEL SENSOR : Exploded . CAUTION: Never pull on wheel sensor harness. 3. Remove brake hose bracket. Refer to BR-20, "FRONT : Exploded View" . 4. Remove caliper assembly with power tool. Hang caliper assembly in a place where it will not interfere with BR-35, "BRAKE CALIPER ASSEMBLY : Removal and Installation" CAUTION: Never depress brake pedal while brake caliper is removed. 5. Remove disc rotor. Refer to BR-34, "BRAKE CALIPER ASSEMBLY : Exploded View" . 6. Remove wheel hub and bearing assembly, and then remove splash guard. 7. Remove steering outer socket. Refer to 8. Remove cotter pin of transverse link and steering knuckle, and then loosen nut. 9. Separate steering knuckle from upper link. 10. Separate steering knuckle from transverse link so as not to damage ball joint boot using the ball joint remover, and remove steering knuckle. CAUTION: Temporarily tighten the nut to prevent damage to threads and to prevent the ball joint remover INSTALLATION Note the following, and install in the reverse order of the removal. wheel hub and bearing assembly and steering knuckle. 1. Steering knuckle 2. Ball seat 3. Cotter pin 4. Splash guard 5. Wheel hub and bearing assembly Refer to for symbols in the figure. JPDIF0166GB |