|
|
BRM-38 < REMOVAL AND INSTALLATION > REPLACEMENT OPERATIONS • Front pillar butt joint can be determined anywhere within shaded area as shown in the figure. The best location for the butt joint is at • Determine cutting position and record distance from the locating indent. Use this distance when cutting the service part. Cut outer • Prepare a cutting jig to make outer pillar easier to cut. Also, this will permit service part to be accurately cut at joint position. • An example of cutting operation using a cutting jig is as follows. Mark cutting lines. 2. Align cutting line with notch on jig. Clamp jig to pillar. 3. Cut outer pillar along groove of jig (at position A). 4. Remove jig and cut remaining portions. 5. Cut inner pillar at position B in same manner. REAR FENDER HEMMING PROCESS 1. A wheel arch is to be installed and hemmed over left and right outer wheel house. 2. In order to hem the wheel arch, it is necessary to repair any damaged or defaced parts around outer CAUTION: Ensure that the area that is to be glued around outer wheelhouse is undamaged or defaced. Procedure of the hemming process PIIA0150E JSKIA0104GB JSKIA0105GB PIIA0153E |