|
|
Content .. 1139 1140 1141 1142 ..
PCS PUSH-BUTTON IGNITION SWITCH PCS-65 < COMPONENT DIAGNOSIS > [POWER DISTRIBUTION SYSTEM] C D E F G H I J K L B A O P N PUSH-BUTTON IGNITION SWITCH Description INFOID:0000000003657684 BCM transmits the change in the power supply position with the push-button ignition switch to IPDM E/R via Component Function Check INFOID:0000000003657685 1. CHECK FUNCTION 1. Select “PUSH SW” in “Data Monitor” mode with CONSULT-III. 2. Check the push-button ignition switch signal under the following condition. Is the indication normal? YES >> INSPECTION END NO Diagnosis Procedure INFOID:0000000003657686 1. CHECK PUSH-BUTTON IGNITION SWITCH OPERATION Press push-button ignition switch and check if it turns to ON. YES >> GO TO 2. NO >> GO TO 4. 2. CHECK IGNITION SWITCH OUTPUT SIGNAL (IPDM E/R) 1. Disconnect push-button ignition switch connector. 2. Check voltage between IPDM E/R harness connector and ground. Is the inspection result normal? YES >> GO TO 3. NO >> Replace IPDM E/R. Refer to PCS-34, "Removal and Installation" . 3. CHECK PUSH-BUTTON IGNITION SWITCH CIRCUIT (IPDM E/R) 1. Disconnect IPDM E/R connector and BCM connector. 2. Check continuity between IPDM E/R harness connector and push-button ignition switch harness connec- 3. Check continuity between IPDM E/R harness connector and ground. Test item Condition Status PUSH SW Push-button ignition switch is pressed ON Push-button ignition switch is not pressed OFF (+) (–) Voltage (V) (Approx.) IPDM E/R Connector Terminal E5 28 Ground Battery voltage IPDM E/R Push-button ignition switch Continuity Connector Terminal Connector Terminal E5 28 M50 4 Existed IPDM E/R Ground Continuity Connector Terminal E5 28 Not existed |