|
|
Content .. 1132 1133 1134 1135 ..
PCS DIAGNOSIS AND REPAIR WORKFLOW PCS-37 < BASIC INSPECTION > [POWER DISTRIBUTION SYSTEM] C D E F G H I J K L B A O P N 1. GET INFORMATION FOR SYMPTOM Get the detailed information from the customer about the symptom (the condition and the environment when >> GO TO 2. 2. CHECK DTC 1. Check DTC for BCM and IPDM E/R. 2. Perform the following procedure if DTC is detected. - Record DTC and freeze frame data (Print them out with CONSULT-III.) - Erase DTC. - Study the relationship between the cause detected by DTC and the symptom described by the customer. 3. Check related service bulletins for information. Is any symptom described and any DTC detected? Symptom is described, DTC is detected>>GO TO 3. 3. CONFIRM THE SYMPTOM Confirm the symptom described by the customer. >> GO TO 5. 4. CONFIRM THE SYMPTOM Confirm the symptom described by the customer. >> GO TO 6. 5. PERFORM DTC CONFIRMATION PROCEDURE Perform DTC Confirmation Procedure for the detected DTC, and then check that DTC is detected again. PCS-107, "DTC Inspection Priority Chart" , and determine trouble diagnosis order. YES >> GO TO 7. NO >> Refer to GI-38, "Intermittent Incident" . 6. DETECT MALFUNCTIONING SYSTEM BY SYMPTOM TABLE Detect malfunctioning system according to based on the confirmed symptom in step 4, and determine the trouble diagnosis order based on possible causes and symptom. >> GO TO 7. 7. DETECT MALFUNCTIONING PART BY DIAGNOSTIC PROCEDURE Inspect according to Diagnostic Procedure of the system. |