Honda Element. Manual - part 233

8. Monitor the OBD STATUS for P1732 in the DTCs MENU with the HDS. 

Does the screen indicate FAILED?  

YES -Go to step 9. 

NO -If the screen indicates PASSED, intermittent failure, the system is OK at this time. If the screen 
indicates NOT COMPLETED, go to step 6. 

9. Clear the DTC with the HDS.  

10. Select Shift Solenoid B in Miscellaneous Test Menu, and check that shift solenoid valve B operates with 

the HDS. 

Is a clicking sound heard?  

YES -Go to step 11. 

NO -Replace shift solenoid valve B (see SHIFT SOLENOID VALVE REPLACEMENT ), then go to 
step 15. 

11. Select Shift Solenoid C in Miscellaneous Test Menu, and check that shift solenoid valve C operates with 

the HDS. 

Is a clicking sound heard?  

YES -Go to step 12. 

NO -Replace shift solenoid valve C (see SHIFT SOLENOID VALVE REPLACEMENT ),then go to 
step 15. 

12. Test-drive the vehicle in the D position through all five gears.  

13. Turn the ignition switch OFF, and repeat the test-drive instep 12.  

14. Monitor the OBD STATUS for P1732 in the DTCs MENU with the HDS. 

Does the screen indicate FAILED?  

YES -Repair the hydraulic system related with shift valves B and C, or replace the transmission, then go 
to step 15. 

NO -If the screen indicates PASSED, intermittent failure, the system is OK at this time. If the screen 
indicates NOT COMPLETED, go to step 12. 

15. Reconnect all connectors.  

16. Turn the ignition switch ON (II).  

17. Clear the DTC with the HDS.  

 

2007 Honda Element EX 

2007-2008 TRANSMISSION Automatic Transmission - Element

  

18. Test-drive the vehicle in the D position through all five gears.  

19. Turn the ignition switch OFF, and repeat the test-drive in step 18.  

20. Check for DTCs with the HDS. 

Is DTC P1732 indicated?  

YES -Go to step 9. 

NO -Go to step 21. 

21. Monitor the OBD STATUS for P1732 in the DTCs MENU with the HDS. 

Does the screen indicate PASSED?  

YES -Troubleshooting is complete. If any other DTCs were indicated in step 20, go to the indicated 
DTCs troubleshooting. 

NO -If the screen indicates FAILED, go to step 9. If the screen indicates NOT COMPLETED, go to step 
18. 

DTC P1733: PROBLEM IN SHIFT CONTROL SYSTEM: 



Shift Solenoid Valve D Stuck ON  



Shift Valve D Stuck  



A/T Clutch Pressure Control Solenoid Valve C Stuck OFF  

1. Warm up the engine to normal operating temperature (the radiator fan comes on).  

2. Make sure that the transmission is filled to the proper level, and check for fluid leaks.  

3. Drain the ATF (see step 3 ) through a strainer. Inspect the strainer for metal debris or excessive clutch 

material. 

Does the strainer have metal debris or excessive clutch material?  

YES -Replace the transmission, then go to step 14. 

NO -Replace the ATF (see step 5 ), then go to step 4. 

4. Turn the ignition switch ON (II).  

5. Clear the DTC with the HDS.  

6. Test-drive the vehicle in the D position through all five gears. 

NOTE:

Before you troubleshoot, record all freeze data and any on-board snapshot, and 
review General Troubleshooting Information (see GENERAL 
TROUBLESHOOTING INFORMATION ).

 

2007 Honda Element EX 

2007-2008 TRANSMISSION Automatic Transmission - Element

  

7. Turn the ignition switch OFF, and repeat the test-drive in step 6.  

8. Monitor the OBD STATUS for P1733 in the DTCs MENU with the HDS. 

Does the screen indicate FAILED?  

YES -Go to step 9. 

NO -If the screen indicates PASSED, intermittent failure, the system is OK at this time. If the screen 
indicates NOT COMPLETED, go to step 6. 

9. Clear the DTC with the HDS.  

10. Select Shift Solenoid D in Miscellaneous Test Menu, and check that shift solenoid valve D operates with 

the HDS. 

Is a clicking sound heard?  

YES -Go to step 11. 

NO -Replace shift solenoid valve D (see SHIFT SOLENOID VALVE REPLACEMENT ), then go to 
step 16. 

11. Select Clutch Pressure Control (Linear) Solenoid C in Miscellaneous Test Menu, and test A/T clutch 

pressure control solenoid valve C with the HDS. 

Does the screen indicate NORMAL?  

YES -Go to step 12. 

NO -Follow instructions indicated on the HDS by the test result, but if the tester has not determined the 
cause of the failure, go to step 15. If any part was replaced, go to step 16. 

12. Test-drive the vehicle in the D position through all five gears.  

13. Turn the ignition switch OFF, and repeat the test-drive in step 12.  

14. Monitor the OBD STATUS for P1733 in the DTCs MENU with the HDS. 

Does the screen indicate FAILED?  

YES -Repair the hydraulic system related with shift valve D, or replace the transmission, then go to step 
16. 

NO -If the screen indicates PASSED, intermittent failure, the system is OK at this time. If the screen 
indicates NOT COMPLETED, go to step 12. 

15. Inspect A/T clutch pressure control solenoid valve C (see A/T CLUTCH PRESSURE CONTROL 

SOLENOID VALVE C TEST ). 

 

2007 Honda Element EX 

2007-2008 TRANSMISSION Automatic Transmission - Element

  

Does A/T clutch pressure control solenoid valve C work properly?

YES -Repair the hydraulic system related with shift valve D, or replace the transmission, then go to step 
16. 

NO -Replace A/T clutch pressure control solenoid C (see A/T CLUTCH PRESSURE CONTROL 
SOLENOID VALVE B AND C REPLACEMENT ), then go to step 16. 

16. Reconnect all connectors.  

17. Turn the ignition switch ON (II).  

18. Clear the DTC with the HDS.  

19. Test-drive the vehicle in the D position through all five gears.  

20. Turn the ignition switch OFF, and repeat the test-drive in step 19.  

21. Check for DTCs with the HDS. 

Is DTC P1733 indicated?  

YES -Go to step 9. 

NO -Go to step 22. 

22. Monitor the OBD STATUS for P1733 in the DTCs MENU with the HDS. 

Does the screen indicate PASSED?  

YES -Troubleshooting is complete. If any other DTCs were indicated in step 21, go to the indicated 
DTCs troubleshooting. 

NO -If the screen indicates FAILED, go to step 9. If the screen indicates NOT COMPLETED, go to step 
19. 

DTC P1734: PROBLEM IN SHIFT CONTROL SYSTEM: 



Shift Solenoid Valves B or C Stuck OFF  



Shift Valves B or C Stuck  

1. Warm up the engine to normal operating temperature (the radiator fan comes on).  

2. Make sure that the transmission is filled to the proper level, and check for fluid leaks.  

3. Drain the ATF (see step 3 ) through a strainer. Inspect the strainer for metal debris or excessive clutch 

material. 

NOTE:

Before you troubleshoot, record all freeze data and any on-board snapshot, and 
review General Troubleshooting Information (see GENERAL 
TROUBLESHOOTING INFORMATION ).

 

2007 Honda Element EX 

2007-2008 TRANSMISSION Automatic Transmission - Element