|
|
Position cap on main headlight and press into place, making sure that the cap engages once at the top and Screwing in the fastening screws 2. Screw in four fastening screws -1- for the cap. Subsequent work - servo motor for headlight levelling system Note After reinstallation or installation of a new servo motor for the headlight levelling system, the headlight must 1. Install main headlight. → 941519 Removing and installing headlight - chapter on "Installing" 2. Connect the Porsche System Tester PIWIS Tester 9718 to the vehicle and start the System Tester. Switch on ignition. >> to continue. 3. Select front end on the control unit, carry out calibration menu. 4. Check headlight setting and adjust if necessary. 997110, 997111, 997120, 997121, 997310, 997311, 997320, 997321, 997410, 997411, 997430, 997431, WARNUNG Gefahr des Verlusts der Text-Bild-Zuordnung beim Ausdruck. Aus technischen Gründen kann derzeit nicht ausgeschlossen werden, dass trotz • Wird der Fehler nicht bemerkt, besteht die Gefahr, daß Arbeiten nicht korrekt • Diagnostic system: reading out fault memory and activating systems Installing main headlight cap 4137 |