|
|
Installing gas discharge lamp ATTENTION Danger of injury! Danger of material damage if bulbs are used or handled incorrectly! → When installed, the headlight has a high voltage. → Only bulbs specified in the bulb table may be used! → Bulbs with a higher wattage may damage the bulb housing! → To prevent short circuits, the load in question must be switched off when changing bulbs! → New bulbs must be clean and free of grease. Therefore, never touch bulbs with your bare hands! To change the bulbs, use a cloth or soft paper. → Observe the safety instructions when replacing a bulb in a Bi-Xenon headlight. → In certain states, it is compulsory to carry spare light bulbs. 1. Replace faulty lamp. Ensure that the lamp is seated correctly when doing so. Inserting retaining bows 2. Insert both retainng bows. Positioning electric connector 3. Position electric connector and turn to the right as far as it will go (bayonet lock). Diagnostic system: reading out fault memory and activating systems Installing gas discharge lamp 4093 |