|
|
Installing multi-function control unit Note The control unit is removed and, if necessary, replaced without reading, writing or coding the data with the Clipping multi-function control unit into steering wheel 1. Attach electric plug connection to multi-function control unit until the plug clicks into place. 2. Clip multi-function control unit into steering wheel. Check that it is secure. Note When removing the locking plate, take note of how many washers are used on each fastening screw. Screwing down locking plate 3. Position locking plate on steering wheel and screw down using the four fastening screws -1- and the washers. → Tightening torque: 4.5 ftlb. Diagnostic system: reading out fault memory and activating systems Installing multi-function control unit 3889 |