Porshe 911 (997). Manual - part 901

 

  Index      Hummer     Porshe 911 997 series - service repair manual 2004-2008 year

 

Search            

 

 

 

 

 

 

 

 

 

Content   ..  899  900  901  902   ..

 

 

Porshe 911 (997). Manual - part 901

 

 

Securing antenna lead to the main wire harness

3. Route the new antenna lead along the main wire harness, guide it through the existing cable ducts and tie

it to the main wire harness using tie-wraps.

PCM plug connections

4. Connect the connectors -D and E- for the new antenna lead to the affected components until the

connectors are felt to engage. The illustration shows the connectors for the PCM display and
operator control unit as an example.

Subsequent work

Subsequent work for PCM/radio antenna lead up to antenna control unit

1. Install PCM display and operator control unit. → 911019 Removing and installing PCM display and

operator control unit - section on "Installing"

2. Install cover for centre console on the left and right. → 681419 Removing and installing cover for centre

console - section on "Installing"

Subsequent work for antenna lead for left antenna amplifier up to right
antenna amplifier

1. Install right air guide. → 853419 Removing and installing air guide - section on "Installing"

2. Install glove compartment. → 681519 Removing and installing glove compartment - section on "Installing"

Diagnostic system: reading out fault memory and activating systems

 Subsequent work

3761

3. Install trim panel under dashboard on the left and right. → 701919 Removing and installing trim

panel under dashboard - section on "Installing"

4. Install A-pillar trim panel on the left and right. → 705719 Removing and installing A-pillar trim -

section on "Installing"

Subsequent work for antenna lead for left antenna amplifier up to
KESSY/PAS control unit

1. Install control unit for KESSY/PAS. → 966619 Removing and installing KESSY control unit -

section on "Installing"

2. Install trim panel under dashboard on the left. → 701919 Removing and installing trim panel under

dashboard - section on "Installing"

3. Install A-pillar trim panel on the left. → 705719 Removing and installing A-pillar trim - section on

"Installing"

Subsequent work for antenna lead for right antenna amplifier up to rod
antenna

1. Install headliner. → 708419 Removing and installing headliner - section on

"Installing"

2. Install right air guide. → 853419 Removing and installing air guide - section on "Installing"

3. Install glove compartment. → 681519 Removing and installing glove compartment - section on "Installing"

4. Install cover on the left and right. → 852219 Removing and installing cover - section on

"Installing"

5. Install battery cover. → 270619 Removing and installing battery - section on "Installing"

6. Install carbon canister. → 202519 Removing and installing carbon canister - section on "Installing"

7. Install rear section of front right wheel housing liner→ 505619 Removing and installing front wheel

housing liner - section on "Installing"

Subsequent work for navigation unit antenna lead up to GPS antenna

1. Install right air guide. → 853419 Removing and installing air guide - section on "Installing"

2. Install glove compartment. → 681519 Removing and installing glove compartment - section on "Installing"

3. Attach relay carrier 1. → 978319 Removing and installing relay carrier 1 - section on "Installing"

4. Install trim panel under dashboard on the left. → 701919 Removing and installing trim panel under

dashboard - section on "Installing"

5. Install trim panels for luggage compartment. → 700519 23 Removing and installing trim panel for

front luggage compartment - section on "Installing"

6. Install navigation unit. → 911219 Removing and installing navigation unit - section on

"Installing"

7. Install cowl panel cover. → 508719 Removing and installing cowl panel cover - section on "Installing"

Diagnostic system: reading out fault memory and activating systems

Subsequent work for antenna lead for left antenna amplifier up to rightantenna amplifier

3762

997110, 997111, 997120, 997121

WARNUNG

Gefahr des Verlusts der Text-Bild-Zuordnung beim Ausdruck.

Aus technischen Gründen kann derzeit nicht ausgeschlossen werden, dass trotz
einwandfreier Darstellung auf dem Bildschirm beim Ausdruck der
Zusammenhang von Text und zugehörigem Bild verloren geht.

• 

Wird der Fehler nicht bemerkt, besteht die Gefahr, daß Arbeiten nicht korrekt
durchgeführt werden und es dadurch zu Personen- und Sachschäden kommt.

• 

→ Vergleichen Sie deshalb nach dem Druckvorgang unbedingt die Ausdrucke mit der
Bildschirmdarstellung. Korrigieren Sie die Ausdrucke im Fehlerfall so, daß der Inhalt der
Bildschirmdarstellung zutreffend wiedergegeben wird.

WARNING

Danger of losing text-figure correspondence when printing out.

For technical reasons, it can currently not be ruled out that the correspondence
between text and associated figure can be lost when it is printed out, even though
the display on the screen is correct.

• 

If the fault is not noticed, there is the danger that work will not be performed
correctly which can cause injury and damage.

• 

→ Therefore, always compare printouts with the screen display after printing them out. Correct
the printouts if they are faulty so that the content of the screen display matches that on the
printouts.

AVERTISSEMENT

Risque de perte de la correspondance texte-illustration lors de l'impression papier.

Pour des raisons techniques, il ne peut pas être exclu à l'heure actuelle que, même
en cas d'affichage correct à l'écran, la correspondance entre le texte et l'illustration
puisse être erronée sur l'impression papier.

• 

Si l'erreur passe inaperçue, on court le risque d'exécuter certaines opérations de
manière incorrecte pouvant conduire à des dommages corporels et matériels.

• 

→ Comparez impérativement pour cette raison les impressions papier avec l'affichage à l'écran.
Corrigez-les en cas d'erreur de manière à reproduire correctement l'affichage à l'écran.

ATTENZIONE

Diagnostic system: reading out fault memory and activating systems

Subsequent work for navigation unit antenna lead up to GPS antenna

3763

Pericolo di perdita dell'abbinamento testo-immagine nella stampa.

Per motivi tecnici non è escluso che, nonostante la rappresentazione sullo schermo
risulti perfetta, durante la stampa venga persa la corrispondenza fra testo e
relativa immagine.

• 

Se tale difetto non viene rilevato vi è il pericolo che i lavori non siano eseguiti
correttamente; ciò può avere come conseguenza lesioni e danneggiamenti.

• 

→ Per questo motivo, dopo la stampa è assolutamente necessario confrontare le stampe con la
rappresentazione sullo schermo. In caso di errore si prega di correggere le stampe, così da
garantire la riproduzione esatta della rappresentazione sullo schermo.

ADVERTENCIA

Al imprimir se corre el riesgo de perder la correcta asignación de las figuras al texto.

Por motivos técnicos, por el momento no se puede descartar que, aun siendo
correcta la imagen que aparezca en la pantalla, al imprimir se pierda la
correlación entre el texto y la figura correspondiente.

• 

Si este error pasara desapercibido, existe el riesgo de que los trabajos no se
ejecuten de forma correcta y, por tanto, se produzcan daños personales y
materiales.

• 

→ Por ello le rogamos que tras el proceso de impresión compare siempre las copias impresas con
la imagen de la pantalla. En caso de error, corrija las copias impresas de forma que se
correspondan con el contenido de la imagen de la pantalla.

Diagnostic system: reading out fault memory and activating systems

Subsequent work for navigation unit antenna lead up to GPS antenna

3764

 

 

 

 

 

 

 

Content   ..  899  900  901  902   ..