|
|
Europe USA South America Australia Asia (South) Africa Japan 13. Select ASK amplifier and code with F8 . ASK amplifier Not installed Installed 14. Select Loudness and code with F8 . Loudness off on 15. Select Factory settings and code with F8 . Factory settings no yes 16. In the menu CDR24, change to MOST actual installed components list; here a version (e.g. CD changer) installed in the vehicle must be displayed 17. Change to MOST required installed components list; here too the same version (e.g. CD changer) must be displayed - if this is not the case, select the version and code with F8 . 18. Select Required & Actual configuration and press the >> . 19. Compare the Actual/Required listing. Use F8 to start Mapping. All installed audio components must now be listed with a plus under Actual/Required. If this is not the case, the versions in the MOST actual or MOST required installed components list must be coded manually. 20. Read out fault memory and erase if required. 21. Use << to quit the menu CDR24. 22. Remove ignition key, close and lock vehicle, then unlock and switch on ignition 23. In the menu CDR24 select Control unit replacement and perform the functions Read codes and Write codes . 24. Read out the fault memory again and erase as necessary. Diagnostic system: reading out fault memory and activating systems Programming the car radio 3741 |